A When Installing a Conveyor
1. Pour gear oil into the gear box before the conveyor is run until the oil reaches the level of the overflow plug. Care must be taken where an electric motor is used to make sure the oil does not reach the motor windings.
B Daily Lubrication
1. Check oil level of gear box by overflow at the oil level plug when the motor is stationary. If necessary top up with the recommended grade of oil.
Note: There may be a few drops of oil trapped in the oil level passage there must be a continuous flow before the correct level is indicated.
2. Fill a small quantity of oil into Thrust Race caps on both the Worm Wheel and Worm Shafts.
3. Where the drive head is exposed to large amounts of dust, grease all nipples daily with grease gun, so forming a seal and preventing dirt entering the bearings.
4. With Compressed Air Motors, maintain the oil level daily with anti-freezing oil — check by overflow plug.
C Weekly Lubrication
1. Grease driving drum bearings.
2. With the Mangle Roller type of drivehead grease Jockey Pulley rocker arms and the pivot bolts on mangle roller heads.
3. Grease nipples on all rollers at drivehead and tension end.
4. On turbine types, inspect oil level in the reversing gear ease and add oil if necessary.
D Monthly Lubrication
1. Pack with grease the driving drum bearings if not provided with lubricators.
2. Add a little gear oil where necessary to oil cap on the electric motor.
3. In turbine drives insert grease into the end of the motor.
4. Inject grease where necessary into the rollers of the intermediate structure, especially where the face is wet or dusty.
E Three Monthly
1. Put high-temperature grease into the electric motor bearings.
Note: The fitting staff normally attend to the lubrication