A The Deputy
Make sure that all the work is carried out safely.
B The Shotfirer
1. See that the alignment of the conveyor is not upset by shotfiring.
C Cuttermen
1. Where anchor props have to be removed at the tension end, see that they are replaced in their original positions and that the belt is correctly tensioned as before.
2. Do not stay the cutting machine to any of the conveyor structure, or the alignment of the conveyor may be affected.
3. Replace correctly any of the intermediate structure that is accidentally forced out of position.
4. Where gummings have to be cast into the goaf do not pile them on top of the belt but throw them over the conveyor into the goaf.
D Fitters
1. Do not load coal on to a stationary belt.
2. Do not place lumps of coal on the belt so large that they will foul the supports or the roof.
3. Keep the following parts of the conveyor as clean as possible by shovelling up all small coal
(a) Tension End.
(b) Sides of the conveyor.
(c) Engine End.
4. Where structure permits, shovel small coal from under the. top belt so that the belt runs on top of the rollers, not on the coal.
E Prop Withdrawers
1. Do not pile the belt up with broken timber or bent steel bars, as they may become fast when the belt is run. Run off the damaged props and bars at the end of the shift after seeing that they are laid properly on the belt.
2. Do not set the anchor props for the sylvesters so that on withdrawal of a prop from the goaf, the sylvester chain will damage the structure or move it out of alignment.
F Belt Attendants
1. Examine the gearbox for overheating occasionally during the shift.
2. With electrically powered conveyors place the isolator switch of the gate end box in the "off" position and place a "DANGER" notice on the switch gear when a conveyor is stopped for repair.
1. Interfere with any machine by removing or discarding any bolts or nuts that may be used on the machine.
2. Remove any cover plate or fence.
3. Put stays between roof and top of motor or gear case.
4. Put packs under gearcase or motor.
5. Use the power to thread the belt.