Where a gate belt gathers the coal directly from the face belt conveyors at the coal face, the gate belt has to be extended with every turnover at the face. This is done in the following ways.
Where there is no Loop Take-up
It is necessary in this case to have specially prepared short pieces of belt the length of which are in proportion to the depth of cut, e.g., twice the depth, four times the depth, or eight times the depth. These pieces are inserted into the conveyor as it is extended until it is possible to replace them by one long length of belting.
1. Advance the line on the roof and clear the floor.
2. Run the belt until there is a joint that can be uncoupled in the top belt reasonably near to the return drum. This will ease the work of pulling the return drum to the face.
| |
Note: |
Where a short piece of belting has to be replaced by the next longer length, run the conveyor so that the short piece is about 10 yards from the return drum.
|
3. Release the tension on the belt by slackening off the sylvesters.
| |
Note: (a) |
Where the return drum is secured by chains to the anchor props, first set up new anchor props in a new position nearer to the face and attach sylvesters to them and to each side of the return drum. Operate the sylvester lever and take the tension from the original anchor props and chains, which can then be removed.
|
| |
(b) |
Release the tension in the belt gradually by means of sylvesters. The sudden release of the tension may cause the return drum structure to fly out into the gate, resulting in damage to the structure and belt.
|
4. Uncouple the joint(s).
5. Remove the telescopic section.
6. Insert whichever short length of belting is required.
| |
Note: |
This length should be such that when the drum is drawn into its new position the whole belt is properly tensioned.
|
7. Draw the return drum almost into its new position by means of the sylvesters.
8. Insert a new intermediate structure when possible and couple the telescopic section to the return drum.
9. Draw the return drum into its final position and align it properly with the line marked on the roof. Level where necessary. Ensure that there will be central loading. Bad loading causes spillage which will end with belt trouble because the return drum will become choked up with small coal.
10. Switch on the power and see that the belt runs centrally on the structure.
11. After proper tension has been applied to the belt, it is advisable to secure the return drum by chains direct to the anchor props or dowel pins rather than to rely on the sylvesters which are liable to be knocked off.
Where a Loop Take-up is Provided
1. Advance the line on the roof and clear the floor.
2. Release the ratchet device on the loop take-up and so release the tension from the belt.
3. Draw the return drum to the position for loading. Extend the intermediate structure and align.
4. Set up permanent anchor props behind the return drum and secure the drum by chains.
5. Operate the ratchet device on the loop take-up to tension the belt.
| |
Note: |
Apply only sufficient tension to ensure that there is no slip between the belt and the driving drums.
|
6. Switch on the power and, if necessary, centralise the belt on the return drum and the loop take-up drum
| |
Note: |
Where there is an insufficient length of belting stored in the loop take-up, uncouple the belt at the most convenient point and pull the return drum into its position for loading. Connect up the extra intermediate sections required and then insert a new length of belting between the ends previously uncoupled.
|