The Blackshale Seam.
It was in the No. 2 Development Unit, South-East District, of this seam that the explosion took place. The seam lies at a depth of 700 yards from the surface, and has an average thickness of 4 ft. 3 in. with an overlying dirt band or "flamper" eight inches thick.
The No. 2 unit (see Plan 1) comprises a longwall face the length of which at the time of the explosion was 192 yards, viz. :— 72 yards on the left side of the main loader and haulage gate and 120 yards on the right of that gate.
In each bank there was a belt conveyor delivering to a gate end loader in the centre gate.
The loader gate was the main intake and, on reaching the face, the air split right and left, the right split returning down the right tail gate and the left split travelling partly by way of the left tail gate and partly by way of No. 9's face, these two latter currents joining in the No. 2 return gate outbye of No. 9 left hand airway (see Plan 2). Two hurdle sheets placed in the left tail gate regulated the quantity passing down that gate and directed the air up into the ripping lip. No. 9 conveyor face had not been worked for some six weeks prior to the explosion.
The width of the loader gate between packs was 12 feet and of the tail gates ten feet, a face ripping six feet thick being carried in the former, and in the latter five feet thick.
The rate of advance of the face was about 25 feet per week, the depth of undercut being five feet, the cutting on this face being done by two machines. The sequence of operations is :— day shift — filling coal; afternoon shift — cutting and filling holings; night shift — ripping, turning over, packing and timber drawing. Shots are fired in both coal and rippings, the average number fired per day being 26 and 12 respectively; coal shots are fired on the day shift and ripping shots at nights.
On No. 2 face 37 persons were employed on the day shift, 20 on afternoons and 32 on the night shift. There was a deputy on each shift, and a shot-firer on the day shift.
The quantity of air entering this district as measured in the intake 100 yards from the face on 8th January and recorded in the air measurement book was 11,600 cu. ft. per minute, and on the same day the measurement in the right tail gate gave 2,800 cu. ft. per minute. No measurement was taken in the left tail gate or on the No. 9 face.
A month earlier the corresponding readings were 13,500 and 3,850 cu. ft. per minute respectively. At the inquest the head surveyor said these measurements were based on the actual velocities recorded by the anemometer and made no allowance for friction; when adjusted in accordance with the makers' chart they would become 11,890 and 3,310 for the 8th January, and for the month of December the quantity in the intake would be 13,840 cu. ft. per minute.
During the three months preceding the explosion the presence of firedamp in the No. 2 unit was reported on twelve occasions as follows :—
@@
It will be observed that most of these reports refer to the finding of firedamp in the left hand gate or gate lip, but that on the 17th and 18th January a small percentage was reported as "giving off at 2's left rib side." In evidence it was explained that the gas was being given off at roof breaks.
On the 11th November, Thomas Barley, a stallman working at the top end of the face, found a small percentage of gas in a pot-hole near the corner when inspecting at the beginning of his shift, and reported this to the deputy; it was cleared as stated in the deputy's report.
In the general body of the air on this face no firedamp had ever been found, and evidence was given to show that at no time had the presence of firedamp been indicated on any flame lamp or automatic detector on the face: the occasions above mentioned refer to the finding of gas at breaks and/or pot-holes.