Opinions As To Cause Of Explosion.
(a) Source of the Firedamp. — There was a divergence of opinion both as to the source of the firedamp which exploded and the means of ignition.
Mr. J. Ivon Graham, Deputy Director of the Mining Research Laboratory, University of Birmingham, called by Mr. Stewart, was of the opinion that there were two possible sources from which firedamp could have come, namely: (a) from the waste owing to barometric changes, and (b) from the soft mushy coal where Samuel Wright was making a "stamp" or "needle" hole for an 8-feet bar prior to the explosion. Mr. Graham discarded the first mentioned source for two reasons : (1) because in his experience in Newdigate and neighbouring collieries there is comparatively little firedamp in the wastes, and (2), although the barometer had been falling for some considerable time prior to the explosion, the rate of fall was so small that, in his opinion, it was improbable, having regard to the amount of ventilation passing along the face, that this change in pressure could have resulted in the emission of sufficient firedamp from the waste to form an explosive mixture in the face.
He thought the firedamp in this explosion had been suddenly emitted from the soft mushy coal. He based this view on his investigations in past years in connection with the amount of firedamp which may be taken up by coal and his experience of the evolution of firedamp from coal, particularly from outbursts in the anthracite area of South Wales.
Mr. Graham was fortified in his view by experiments which he made on samples collected by him of the soft mushy coal and of the normal hard coal in the Two Yard seam. He found that when samples of the mushy coal had been saturated with firedamp at a pressure of nearly one atmosphere, and were then subjected to a reduction of pressure of four-fifths of an atmosphere, they gave off in one minute 75 to 80 per cent. of the firedamp which had been put into them, whilst the sample of normal coal under similar conditions gave off only 1 per cent.
He explained that the tendency would be for the gas contained in the fine mushy coal in 6's face to be evolved very rapidly once that coal was exposed, and that the most probable point from which the gas in this explosion was given off was Where the bar was being set by Wright and where, after the explosion, a slip of coal was found to have fallen off the face. He calculated that from 10 tons of the soft coal 200 cubic feet of firedamp could be evolved in one minute.
Messrs. Smith, Yorke and Wightman also thought that the fire damp had come from the "slip-fault".
Mr. Rowley's opinion as to the source of the firedamp, given in his own words, was as follows :— "There were a lot of things operating that day which to my mind would tend to produce gas. You had a low barometer and you had the place on weight. You had the face somewhat disturbed and you would have gas given off from all these causes, chiefly though coming from the waste because of the low barometer
Mr. James McCallum, a witness whose work and testimony were very impressive, thought that the presence of firedamp was due to the heavy weighting which was on the whole length of 6's stall.
(b) Means of Ignition. — After the explosion, an electric lamp, No. 348, with its well glass and bulb glass broken, was found lying on the floor next the conveyor on the face side. The exact point along the face at which this lamp was found was in dispute. Mr. Rowley and Mr. Scott said the position as measured by tape and written down at the time the measurement was made, was 14 yards from 6's gate road. Mr. James Hamilton, Manager of Exhall Colliery, said he paced the distance from the lamp to 6's gate road and found it to be 25: paces, and this distance, which he called 25 yards, he wrote down in his note book at the time. Other witnesses spoke to finding the lamp at a point in front of the second waste, that is some 22 yards from 6's gate road.
The position of the lamp when found was of importance from the fact that, in the opinion of Mr. Graham and Mr. Smith, firedamp emitted from the soft mushy coal at the slip fault had been ignited by the still glowing filament of this electric lamp after the well glass and bulb glass had been broken.
This lamp had been issued to J. W. Morris, who with J. Blackwell had been put to hew off a knob of coal, and assuming that it was found, as, according to some witnesses it was found, opposite that knob of coal, the events visualised by Mr. Graham and Mr. Smith were :— Morris is hewing at the knob of coal with the lamp hanging near him: inadvertently he breaks the well glass and the glass of the bulb of his lamp by a stroke of his pick or other tool, and firedamp, issuing at the time from the mushy coal at the "slip-fault", is ignited at the still glowing filament.
This lamp was sent to Captain C. B. Platt, the Mines Department Superintending Testing Officer at Sheffield, and there examined. He found the filament broken, the fractured ends as seen through a microscope being blunt and not having the needle-like formation which would have been the case if the break had been due to burning in air or a mixture of firedamp and air.
Captain Platt produced micro-photographs of the broken filament which did not altogether appear to bear out his observation that the fractured ends were blunt, but he explained that his evidence was given not on what was shown by the photographs but on what he actually saw through the microscope, it being difficult to get a photographic result exactly as seen by the eye through the microscope.
Mr. Rowley did not agree that the broken electric lamp was the means of ignition. He considered that the firedamp had been ignited at the conveyor motor. He based that opinion on the fact that the face rose to the top end in which that motor was placed and he considered, when the firedamp was being given off from the waste, that point would be the most likely place for it to accumulate. He thought that if the broken lamp had been the means of ignition, in view of the contour of the face, a very much larger explosive mixture must have been present than, judging by the effects of the explosion, was in fact present.
That an explosive mixture could have been ignited at the conveyor motor was given in evidence by Mr. J. A. Bernard Horsley, H.M. Electrical Inspector of Mines, who, when examining that motor on the day following the explosion, found a defect in the electrical contacts of the plug connector. This defect consisted of evidence of electrical burning or arcing between the pin and socket contact which served to convey the current from the plug on the trailing cable to the conveyor motor.
This plug was of the flat bat or pummel type containing three socket contacts in line. When the plug is pushed into the socket box on the motor the socket contacts in the plug engage with three pin contacts on the motor.
Two of these contacts, Mr. Horsley said, appeared to be unmarked but the third one showed obvious signs of electrical burning; the plug did not make a close fit in the socket, consequently firedamp would have access to the arcing contact which would be capable of igniting firedamp in explosive proportions and the flame would spread without difficulty to the surrounding atmosphere.
Mr. John Mackay, electrical tester for Messrs. Mayor and Coulson, who examined the conveyor motor and gave evidence, agreed that there were indications of arcing on one of the pin contacts, there being a general surface roughening on part of the surface towards the point of the pin. He thought some coal dust or something of that kind had got between the pin and the socket and intimate contact had thus been prevented; the plug was not flame-proof, but the pins were a good fit in the sockets and if the bolt which locks the plug in position is screwed tight home, the whole arrangement would be reasonably safe.
A copy of this report was kindly donated by
West Cumbria Mines Research.