I. - DESCRIPTION OF THE COLLIERY
(1) General. Eppleton Colliery is a large extensively worked mine, sunk in 1825, situated near the village of Hetton-le-Hole, Mid-East Durham, about six miles northwest of Durham City and south of Sunderland respectively. It is in Group "C" of No. 2 Area, Durham Division of the National Coal Board. The seams being worked, in descending order, are the Five Quarter, Main Coal, Maudlin, Low Main and Busty; the Hutton Seam which lay between the two last-named seams has been worked out.
The mine is served by three coal winding shafts Jane Pit 12 feet diameter to the Busty Seam at 434 yards; Caroline Pit 11 feet diameter to the Hutton Seam; and Lindsay or New Pit 16 feet diameter to, and 10 feet diameter from, the Hutton Seam down to the Busty Seam. Jane and Caroline shafts are both downcasts and Lindsay is the upcast shaft.
The Busty Seam - the only seam we are concerned with - is wound up Jane shaft. Ventilation is produced by an electrically driven double-inlet Sirocco fan, 154 inches diameter, capacity 287,000 cubic feet per minute at a watergauge of 2.3 inches.
During 1939, in order to fully develop the Busty Seam and to balance the relatively high water-gauge required to overcome the extra resistance due to the small shaft area and extensive workings, a large booster fan was installed in the seam near the upcast shaft. This electrically driven Sirocco fan, 120 inches diameter, with a capacity of 130,000 cubic feet at a water-gauge of four inches, is kept running constantly to serve the whole of the Busty Seam workings. The amount of air entering the South Side (comprising 69, 69A and 69B Districts) is 46,700 cubic feet.
(2) Management. The principal officials are as follows :-
| Area General Manager | | Mr. A. H. Kellett |
| Area Production Manager | | Mr. J. N. O. Rogers |
| Group Agent | | Mr. W. Stokoe |
| Manager | | Mr. W. C. Elliott |
| Undermanager, Busty Seam | | Mr. S. B. Martyn |
| Undermanager, other Seams | | Messrs. T. W. Stout and A. K. Nutman. |
(3) Safety Lamps. The seams are not particularly gassy but firedamp is a hazard in all of them and safety lamps have been used throughout the mine for many years. The lamps in general use for workmen and deputies are the Oldham G.W. electric cap lamps (self-servicing) and Patterson h.c.p. flame lamps. The deputies also carry Patterson G.T.L.9 flame lamps and senior officials Patterson G.T. re-lighter lamps for gas testing purposes.
Automatic firedamp detectors are not required by the regulations but they were available, if necessary. Selected workmen carry the Patterson type A.1 flame lamps (Schedule B) as gas detectors, a matter which I shall refer to later in this Report.
(4) Busty Seam. This seam at the colliery ranges between 5 feet and 6 feet in full section with a varying middle band of stone which is very thick in places. A strong sandstone averaging 30 feet in thickness overlies the seam and in some areas forms the nether roof, but in other areas blue shale or laminated post intervenes. The floor comprises a dark shale 6 to 1 5 inches thick underlain by grey metal. The coal has a volatile matter content on an ash-free dry basis of 36 per cent. and yields a good gas coal.
The seam has been worked extensively for about 25 years, mainly by ordinary bord and pillar mining using pneumatic picks and loading into tubs, but in a more recently acquired area of the now defunct Hetton Colliery, lying to the south of the Eppleton shafts and below a 48-feet drop fault, it was decided in 1945 to adopt American machinery together with British arcwall machines to form pillars for later extraction where the question of surface support permitted.