Site of Colliery. – In choosing the site of a colliery there are two sets of considerations – those referring to the surface and those referring to the minerals. Taking the surface first, the pit would be conveniently placed near a railway, or canal, or highroad, by which means of conveyance the produce could be despatched, and machinery and materials brought to the mine; on the other hand, a colliery might be most conveniently situated on that side of the estate where the minerals are deepest, because with a pit sunk at that point the pumping-engine in that pit would drain the whole estate of water, and it would be unnecessary to employ hauling-engines to drag the coal to the pit-bottom, as the coal could be brought to the shaft either by gravitation or by horses. It might, however, happen that the place suggested by mineral considerations might be on the top of a high mountain, or separated from the railway by a broad river, or by some strip of land over which there was no right of way, or some other impediment might exist which would overrule the mining considerations. Supposing, as far as the surface is concerned, it is a matter of comparative indifference where the shafts are sunk, then, in the case of a large estate, it is generally best to sink the pits as near the centre as possible; as there will be sufficient coal to the rise to last for twenty or thirty years. The pits will not be so deep as if they had been sunk at the extreme dip of the estate, and the length of haulage – that is to say, the distance that each ton of coal will have to travel underground from the working place to the shaft – will be on the average little more than half what it would be if the shafts were sunk at one side of the estate; and when it becomes necessary to get the coal from the dip side of the estate, it can be drawn by hauling-engines to the pit-bottom. In most deep collieries the amount of water finding its way into the dips is not a very serious consideration. For a large colliery it is necessary to have a railway, and it is an advantage to have also a canal and a good road. Pits are sometimes most advantageously situated on the side of a harbour or deep water inlet of the sea, so that the coal can be tipped directly into ships.
Sinking. – The site of a colliery having been chosen, the position of each pit is marked out. There must always be two shafts, and there are often three – one for pumping the water, one for a downcast shaft for the air, and the third for an upcast shaft for the air. In deep collieries the pumping-engine shaft seldom goes to the bottom, as the lower strata are dry; it is necessary that between two of the shafts, at each of which there must be a winding-machine, there should be a thickness of not less than 15 yards of strata; this is fixed by the Mines Regulation Act, 1887, sect. 16, sub-sect. B.
Unsoiling. – The first operation of sinking is to take off the soil for a depth of say 1 foot over the area likely to be occupied by the works and spoil-heaps, removing it to some place where it will be out of the way; this is a good practice, but not always observed nowadays, owing to the expense. The reason for it is that, after the mine is abandoned, the soil can be again spread over the ground, which will thus be restored to agricultural condition. In the case of collieries, however, likely to last a great many years, it probably does not pay to incur the expense of removing the soil for this purpose.
Excavation, and Shape. – The second operation is to begin digging the pit, or shaft, with picks and shovels. In England the pit is usually circular; in South Wales some pits have been sunk of an oval shape; and in Scotland there are many rectangular pits. On the Continent pits vary in shape, and in the United States the pits are generally rectangular. The size of colliery shafts in England nowadays varies from about 6 feet up to about 18 feet, and the usual size for first-class collieries, that is, collieries raising 1000 tons a day and upwards, is from 14 to 18 feet in diameter. By means of the pick and shovel alone, the depth of the pit will not be taken more than 3 or 4 yards, the dirt being thrown up on to intermediate platforms; it is then necessary to employ windlasses to raise the material in buckets, by which means the pits can be carried down to a depth of 20 yards. Twenty-five years ago and more it was usual to get a horse-gin, with which the depth of the pit could be increased to 40 or 50 yards, and after that a steam-engine was employed; nowadays a horse-gin is seldom used for colliery work, and a steam-engine is erected at once. As soon as the solid strata are reached, the pick by itself will make but slow progress, and it is necessary to employ gunpowder or other explosive.