Museum
Friends of Durham Mining Museum
Events Calendar
Join our Friends!
Newsletter Contents
Items for sale
Items for Sale
e-Books
Photograph Gallery
Document Archive
Discussion Forums
What's new in the site

Mining History
Colliery Index
Colliery Maps
Educational Material
Bibliographye
Workers/Employee Lists
Notes for Family Historians

Disaster Reports
Names of those killed
Disasters in the 1700s
Disasters in the 1800s
Disasters in the 1900s
Memorials

Links to other sites of interest
Industrial Heritage Days Out

View our Guestbook

Index to site



Mail: Webmaster


Chapter IV

NOTES ON CARE OF BELTING

Important Points

1. All hooks of the fasteners should be properly bent over and all rivets should be properly hammered over so that they will not catch on the conveyor structure.

2. Belt corners should be trimmed at joints to prevent the ends of the belt catching on structure and tearing the belt.

3. Belt joints should be made so that both lengths of the belt are aligned correctly. If the ends of the joints are staggered the projecting ends will catch on the structure and tear.

4. The fasteners should be evenly spaced over the joint to distribute the tension equally over the whole width of the belt.

5. For the same reason the two lengths of belt to be joined should be of the same width.

6. Joint pins should be long enough to pass through all the fasteners to even out the tension over the whole width of the belt.

7. Joint pins should not be so long that they project from the joint edges or they will foul the sides of the conveyor and may cause the belt to slip or break.

8. Any damaged joint should be repaired immediately as it will always be a source of weakness and may break in the engine end or return drum where it is difficult to repair.

9. All bent or damaged side plates, stools or standards, bottom belt cover pans or rollers should be replaced so that the belt will not be subject to excessive wear.

10. Any torn belt edges should be trimmed to prevent the belt tearing further. The torn belt should be replaced by a new length at a convenient time during the shift.

11. Keep all rollers clean, so that they rotate freely and do not add to the friction.

12. Make sure the plough is working properly at the tension end and that the return drum is not clogged up with small coal.

13. The belt should be made to run centrally on the return drum and on the drive head. If it does not, it may tend to double over and split.

14. Spare lengths of belting with belt fasteners affixed should be kept in the gates at either end of the face to replace any damaged pieces of belting, so saving time in making new joints.

15. Excessive tension in a conveyor belt increases the power required to drive it round. It also increases the likelihood of cuts and breakages occurring in the belt, and of belt fasteners being pulled out.

16. It is very important that the two belt ends at the joint should be square. If they are not it may be difficult to insert the coupling pin and the belt at the joint will run out of line on the conveyor structure.

17. Where ordinary fasteners corrode owing to dampness at the face, it may be advisable to use a stainless steel type of fastener.

18. All the belting should be examined periodically and any badly worn or damaged portions be replaced to avoid belt breakages during the shift.

Prev Page Return to Top of Page Next Page



Back

Home
Copyright © 1999-2012 by The Durham Mining Museum and its contributors
Page last updated: 01 Jan 2008

Search

Print