called the crucible ; and in it is collected the fused metal reduced by the operations of the furnace, until a sufficient quantity for tapping has been accumulated. The three continuous faces of the hearth are perforated a little above the level of the tymp with holes for receiving the nozzles of tuyeres, which convey the blast from the blowing machine to the furnace. The vaulted galleries allow the workmen to pass from one tuyere to another without loss of time. Each of the pipes which connects the tuyeres with the blowing machine is furnished either with a throttle valve or slide worked by a screw on the outside, by which the quantity of air admitted into the furnace is regulated, or if necessary entirely cut of. The tuyeres, which are built into the hearth, are conical tubes of cast Iron, and to prevent them from being melted by the intense heat of the furnace, they are made hollow, and a current of cold water allowed to circulate through them, one pipe bringing the cold water and the other discharging it after it has been heated. Within these tuyeres are placed the nozzles of the blast pipes; and by settling the tuyeres somewhat at an incline, the blasts do not meet each other, but each one operates upon a different part of the hearth.
In practice it is usual to build two or more of these blast furnaces side by side, and when the situation permits, it is found advantageous to place them at the bottom of a declivity in such a way as to be enabled to connect their summits with the adjoining high ground by means of a bridge. By this arrangement it becomes easy to supply the furnaces with the necessary ore and fuel; but if this method, from the nature of the country, cannot be adopted, it is either raised by an inclined plane and waggons worked by the engine of the blowing machine, or by a moveable platform raised by compressed air or hydraulic pressure. The tops of the furnaces are generally enlarged by a platform, which, to prevent accidents is railed round, and when the moveable stage is employed, the ore and other matters are raised in iron waggons, which can be readily transferred to a continuation of railway laid on the platform of the furnace, and which conducts them directly to the throat, where they are shot by tilting the waggons. The dimensions of blast furnaces differ very much according to the nature of the product which is sought to be produced. The height of some is only 36 feet, including the chimney; whilst others reach an elevation of 60 or even 70 feet from the ground. The most common height, however, is from 45 to 50 feet, to which must be added that of the chimney, which is from 8 to 10 feet in length. The openings, or usually two doorways, are left on the opposite sides of the base, for the introduction of the ore and fuel.
The following measurements represent the interior of two well-going furnaces :— First :— Height from hearth throat to mouth, 45 feet; of the crucible or hearth, 6½ of the boshes, 8; of the cone, 30½; of the chimney or mouth, 8. Width of the bottom of the hearth, 2½ feet; of its upper end 3 of the boshes 12.66; at one-third of the belly, 12 ; at two-thirds of the belly, 8.66; at the mouth, 4½ — inclination of the boshes, 59°. Second :— Height from hearth throat to mouth, 49 feet; of the crucible or hearth, 6 ; of the boshes 7; of the cone, 36 ; of the chimney or mouth, 12¾. Width of the bottom of the hearth, 2 feet; of its upper end, 2.66; of the boshes, 13½; at one-third of the belly, 11½ ; at two-thirds of the belly, 9½; at the mouth, 3.66 — inclination of the boshes, 52°. The erection of a pair of blast furnaces of 40 feet in height requires 320,000 common bricks for the outside masonry, and 80,000 fire-bricks for the refractory lining on the inside. Some of the largest furnaces are in South Wales, in which the diameter at the boshes, or widest part, is from 15 to 18 feet. These have a capacity of 7,000 cubic feet, and contain at least 150 tons of ignited materials; those in the neighbourhood of Pontypool are of a much less massive construction, as the upper and lighter portions of the work are composed of a single thickness of bricks only. The whole apparatus is strongly bound together by a proper arrangement of iron stays, and is found to be quite as durable as those built with an external coating of heavy masonry. In the vicinity of Glasgow, where the hot blast is used, the body of the furnace is usually made of a cylindrical form. A well-constructed furnace will work four or five years without requiring repair, and then only the refractory lining will have to be re-constructed. Some of the Welsh furnaces have been worked for more than ten years without requiring any extensive repairs, and at the end of that time, only the lower portions of the lining have required re-construction.
Some interesting suggestions for an improvement in the construction of the blast furnace are given by an intelligent correspondent in the Mining Journal of Feb. 25, 1860. "In some peculiar sectional figure," he observes, "of the interior of the furnace, a good deal was relied upon for the favourable progress of its operations; and some importance was also attached to the sectional conformation of the interior; it is not, however, the case now to yield much faith in any particular shape, but rather to secure a large amplitude of room. The modern enlargements of the hearth and the throat, both of them the result of slow growth, I consider to be important improvements ; the first, inasmuch as its durability is more than doubled, and its capacity rendered suitable to increased operations ; but at the same time I am of opinion that, unlike the throat, it may be made too large, and that 5 feet, if not perhaps of the widest, should not be exceeded, for the following reasons, viz. — That the blast, when delivered into the hearth (especially as is now common with hot air, into or against a bright tuyere), penetrates but little within the materials, leaving a not very small portion before it, not directly acted upon by it; whereas to increase the width of it might possibly add to the evil just named; of course I am supposing that not less than three tuyeres are used. The cold air formerly applied had the effect of cooling, and in a great degree hardening, the matter it came in contact with on its delivery from the blow pipe, and thereby formed a kind of natural hollow honey-combed tuyere, which extended to a length of more or less than 8 or 10 inches into the mass, admitting at once the air freely into the body of materials both before and above it. A furnace never worked so well as when this condition prevailed, particularly with the single as well as the double tuyere; but when three tuyeres or more came into use with a largely increased quantity of hot blast, there was an end to honey-combed tuyeres, and bright ones now are only known under the circumstances. The enlarged dimensions given to the vent or throat of the furnace afford relief by a freer discharge of the gases, and for that purpose can hardly be too wide; but it is necessary that a limit should be observed to suit the convenience of charging, which is now generally done from a gallery round the throat. As regards the lateral enlargement of the furnace to gain capacity, I believe the motive entertained was chiefly to promote increased production, irrespective of the better reason that a certain collection of materials was necessary to lie in contact in order to promote the process of cementation. To some extent this opinion is doubtless correct.
"I am led to think that the sectional swelling out of the body of the furnace, to obtain an enlarged capacity, is not requisite
Please Note: These web pages retain the original pagination from the publication