Explosion At Llantrisant Colliery,
East Glamorganshire
Report By Mr. J. Macleod Carey, O.B.E.
2, Museum Place,
Cardiff
4th November, 1941.
D. R. Grenfell, Esquire, C.B.E., J.P., M.P.,
Secretary for Mines.
Sir,
I have the honour to submit the following Report upon the explosion that took place on 2nd June, 1941, at Llantrisant Colliery, owned by the Powell Duffryn Associated Collieries Limited, by which four persons were killed and three injured.
Description Of Colliery.
The Colliery is situated in the Parish of Llantrisant, in the County of Glamorgan, some nine miles West of Cardiff. It consists of three shafts, two of which, Nos. 1 and 2, are sunk to a depth of 598 yards to the Lower Coal Measures, and the third to the No. 2 Rhondda Seam, lying at a depth of 205 yards, from which shaft the No. 3 Rhondda Seam was worked. The latter seam, after being worked somewhat extensively, was abandoned some nine or ten years ago. As these workings have no direct bearing upon the disaster, no further reference to them need be made.
The shafts are sunk on one side of the Ely Valley, about one mile North of the South outcrop of the Coal Measures. The ground being much disturbed, only exploratory work has been done in the Lower Coal Measures, as shown on Figure 1, from which it will be seen that the workings vary much in both direction and rate of dip. Three seams, known respectively as the A., D. and G. seams, were explored with one small drivage in what was known as the "A" seam. The correlation of these seams with the well known seams of the Steam Coal Series is as yet uncertain. They were, however, gassy; and as work proceeded and roadways were abandoned they were bashed off. Finally, when the work of exploration ceased in March of this year, only a single roadway, forming the main airway between the upcast (No. 1 Pit) and the downcast (No. 2 Pit) was left open.
All the plant and machinery were driven by electric current supplied by the Company's own mains, from the Bargoed, Aberaman and Penallta Collieries generating stations. There were two fans made by Messrs. Walker Bros., of Wigan, each designed to supply 200,000 cubic feet of air per minute, at a water gauge of inches. During the concluding stages of exploration neither of the fans was used. Natural ventilation, said to amount to 25,000 cubic feet per minute, was sufficient to maintain the workings in accordance with the requirements of Section 29 of the Coal Mines Act, 1911.
On 24th March, 1941, permission was given by me for the use of naked lights in the form of acetylene burners in the No. 2 Shaft, for the purpose of dismantling the guide ropes below a point in the shaft where the Hafod Seam was struck, i.e., at a depth of 379 yards from the surface. Stringent conditions were attached to this permission, one of which was that the fan must be used in reverse so as to convert the No. 2 or upcast pit into a downcast pit during the operation. In fact, upon the completion of this operation, the No. 2 pit remained the downcast, and the No. 1 pit became the upcast, and so it remained up to the morning of the 2nd June. The purpose of the removal of the guides was to clear the shaft below the horizon of the Hafod Seam, and fill it up to that level with debris produced in the drivage just commenced in this seam, which was to serve the double purpose of developing the seam, and, by driving at cross measures to a point in the old airways in the Lower Measures, to form a return airway, connecting through them to the No. 1 Shaft (Figure 1); also by filling the shaft a new and solid foundation would be formed for the Hafod Seam landing, a skeleton platform meantime being constructed and used as a temporary landing for the cage. So as to maintain a current of air during the operation of filling this shaft, and until the new drivage was completed, a steel and concrete tunnel, 4 feet in diameter, was built at the bottom of this shaft. (See Figure 3.)
The workings below ground were dry. Water made in the shafts was pumped to the surface by electrically driven pumps situated in the No. 2 Rhondda Seam at a depth of 260 yards, such water as fell to the bottom of the shafts being lifted to the surface by a water barrel in the No. 1 upcast pit.
Since the damage caused by the explosion took place mostly at the surface of the mine and not below ground, it is desirable to describe in some detail the surface "layout" as illustrated by Figure 2.
The main machinery, consisting of the winding engines, air compressors and fan engine, was all housed in one building, at the southern end of which the fan-house was situated. There were other buildings used as stores and workshops; the lamp room; a capstan engine house, known as the "sand-cabin" ; the manager's office; and the banksman's cabin close to the top of the No. 2 pit. In addition, there was the usual screening equipment.
The air-lock at the top of the No. 2 shaft consisted of two sliding wood covers which were lifted up and lowered by the cages. Only one cage was in service however, and the other was suspended near the surface supported by two girders across the shaft, with the wood cover idle above it. Thus it follows that the top of the downcast pit being partially closed in by these two wood covers or "flappers," the bulk of the air must have passed through the fans, down the fan drift, and so into the shaft.
A copy of this report was kindly donated by
West Cumbria Mines Research.