|
II. DESRIPTION OF THE COLLIERY.The Lyme Colliery is one of a group of five collieries belonging to Messrs. Richard Evans and Company Ltd., and it is situated at Haydock about three miles east and slightly north of the Borough of St. Helens. The two shafts were completed in 1924. No. 1 shaft is the downcast and is sunk to the Lower Florida seam at a depth of 396 yards; coal from that seam and the Higher Florida seam is wound in it. No. 2 shaft, sunk to the same depth as the downcast, is the upcast, and coal from the Potato Delf and Wigan Four Feet seam* is wound in it from a depth of 281 yards where the former seam is intercepted. At a distance of about a quarter of a mile East from the shafts, a large fault with an upthrow of 240 yards to the East interrupts the strata and brings the Wigan Four Feet seam, in the workings of which the explosion occurred, nearly to the same horizon as the Potato Delf seam. The former seam was recovered by a pair of stone drifts or tunnels driven across the fault from workings in the latter seam. Plan No. 1 is a general plan showing the lay-out at the time of the explosion of the workings in the Wigan Four Feet seam and the roadways in the Potato Delph seam connecting the workings with the shafts. These workings are known as the No. 1 West District of No. 2 Lyme Pit. The plan also shows (a) the ventilating system, the intake airway being shown in blue and the return airway in red; and (b) the quantity of air in circulation as measured at various points in the workings on the 26th February, 1930. On reference to Plan 1, it will be seen that immediately adjacent to the fault and for some distance beyond it the seam was developed by headings driven in the solid coal. At a later stage, a longwall machine cut conveyor face was opened out from a level known as the "Conveyor Level." Including a short length at the deep side of the level, the face was 100 yards in length and was advancing nearly parallel with the line of full dip of the seam, viz. : 1 in 5½. Both the coal cutting machine and the conveyor engine were driven by compressed air, and compressed air was also used for drilling shot holes, and for auxiliary haulage and pumping in the district. The section of the seam was as follows :—
The shale roof persisted as shale to a distance of 16 yards above the seam where a borehole had proved the existence of another seam of coal. A boring downwards had also proved a third seam of coal at a similar distance below the Wigan Four Feet seam. Supervision. — The supervision of the Colliery was carried out by the following staff. Mr. F. B. Lawson, General Manager and Agent of all the collieries of Messrs. Richard Evans & Co., Ltd.; Mr. H. Whitehead, Manager; Mr. C. M. Coope, Under-Manage! of No. 1 pit-at the time of the explosion the post of UnderManager of No. 2 pit had been vacant for five months; an underlooker, Mr. J. F. Pickett, holding a second Class Certificate of Competency, was performing for the time being the usual functions of an Under-Manager in No. 2 pit, but he had not been formally appointed to act as under-manager. In addition there were for the No. 2 Pit nine firemen, four on the day shift, two on the afternoon shift and three on the night shift. Normally, during the afternoon and night shifts, the workings were not visited by any official superior to a fireman. The inspection required by Section 64 (1) of the Coal Mines Act, 1911, to be made within two hours of commencing work in any shift was made and reported generally by the fireman of the preceding shift. The station required by Section 63 of the Coal Mines Act, 1911, to be fixed for the purposes of inspection before the commencement of work in a shift, was fixed for the Wigan Four Feet seam, or, as it was called, the No. 1 West District, at the junction of the ‘Conveyor Level with the Main Brow as shown on Plan i. The total number of persons employed in the No. 1 West District on three shifts was on an average 100 for an output of about 140 tons per day. Ventilation. — The ventilating system has already been referred to above and it is shown in considerable detail on Plan i. It calls for no adverse criticism as to either the quantity or the method of distribution. Safety Lamps. — Flame safety lamps were used generally throughout the workings, but electric lamps were issued to coal cutting machinemen, conveyor pan men, drillers and fitters. A few workmen were provided with two lamps. Shot firing. — Shots were fired in the rippings and in the coal in the No. 1 West District, the permitted explosive used being Polar Viking Powder with No. 6 H.T. Detonators. Shots were fired on all of the three shifts, but in no great numbers except on the night shift, during which an average of about 20 shots per shift were fired by a shot firer in the freshly cut coal. There was a shot firer also on the day shift to fire shots as required in the conveyor face and in the pillar workings to the dip. Firing on the afternoon shift was confined almost solely to the rippings and it was done by the fireman without assistance. Coal Dust. — The quantity of coal dust in the face and on the roadways does not appear to have been very great and, in accordance with the provisions of the General Regulations of 30th July, 1920, as amended 20th November, 1924, it was diluted by the application of Chance's Mud, a carbonate of lime which is a waste material from certain large scale chemical processes and has been proved by experience to be eminently suitable for this purpose. In a period of six months prior to the date of the explosion, Chance's Mud was distributed in the roadways of the mine at the average rate of about 2 lbs. per ton of output. Inert dust was applied by hand daily in the roadways of No. 1 West District, and in the face prior to the firing of the coal shots by means of a blast of compressed air from a pipe placed in a bucket of dust at the intake end of the face. General supervision of the stone dusting arrangements was exercised by an assistant of the Agent, who was responsible for taking samples and for having them analysed. Thereafter, each Manager was furnished with the results of the analyses of the dust samples from his pit and he was then responsible for seeing that remedies were applied in any case in which the analyses showed they were necessary. Firedamp. — The Wigan Four Feet mine is recognised to be a seam which gives off firedamp somewhat freely, but in these workings the general ventilation was such that firedamp was rarely present in sufficient quantity to be detected on the flame of a safety lamp. It was, however, stated in evidence that after the opening of the longwall conveyor face the first heavy weight was accompanied by an efflux of water and very large volumes of firedamp which for the time being overpowered the ventilating current, ample as it was for ordinary circumstances, and compelled a temporary suspension of work in the district for several days. Roof Supports. — The roof in the conveyor face was supported by steel props (tubes with a timber core) and corrugated bars or straps. The roof in the roadways was supported generally, where supports were required, by steel arch girders, which were used practically right up to the face of the canches in the Conveyor Level and the Main Slant. A considerable length also of the Main Brow was similarly supported. In the pillared portions of the district, where the top coal was left up as a roof, little artificial support was necessary, but, where required, props or props and bars were used for the purpose as well as here and there a chock. * In the Lancashire Coalfield the word "Mine" is frequently used instead of the word "Seam."
|
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 31 Dec 2022
|
Search |
|
|||