Appendix III
Ignitions by Impacts between Rocks and between Rock and Steel
Maindy Colliery, 1896: In the clearing of a fall, a cavity 18 feet high was created a fall in the cavity is believed to have been responsible for an explosion occurring whilst no one was in the mine. (Explosion at Marine Colliery, Monmouthshire: Report by Sir Henry Walker, C.B.E.: Cmd. 3048.)
Ferndale Colliery, 1907: A small quantity of gas was believed to have been ignited by a fall of strong siliceous rock from a place about 12 feet above floor level during the clearing of debris brought down in repair work. (Report on Marine Colliery explosion.)
Belle Vue Colliery, Alberta, Canada, 1910-1911: Three separate explosions occurred during the extraction of pillars in a 13 feet thick seam inclined at an angle of 45 degrees; it is believed that the ignitions were due to collisions between pieces of bituminous sandstone as they fell down the steeply inclined roads. (Stirling and Cadman, Transactions of the Institution of Mining Engineers, Volume XLIV, page 740.)
Lletty Shenkin Colliery, Cwmbach, 1913: Repairers were working at a fall when another large fall of stone occurred; they saw flame rising when the stone fell on some iron bars. (Report on Marine Colliery explosion.)
Minnie Pit, 1918: The fall of a siliceous stone from a place about 12 feet above the floor of a thick coal seam worked by pillar and stall was given as a possible cause of the explosion. (Explosion at Minnie Pit of the Podmore Hall Colliery, North Staffordshire: Report by W. Walker, C.B.E.: Cmd. 810.)
Mine in Germany, 1922: An explosion was produced by the impact of a large piece of sandstone on a steel roof support arch. (U.S. Bureau of Mines Information Circular 7727 (Hartmann).)
Hillcrest Mine, Alberta, Canada, 1926: Mr. G. S. Rice, Chief Mining Engineer of the U.S. Bureau of Mines, came to the conclusion that frictional sparks or heating due to falling and sliding rock were possible causes of the ignition of firedamp. (Safety in Mines Research Board Paper No. 46. 1928.)
Marine Colliery, Monmouthshire, 1927: Sir Henry Walker considered that the explosion may have been due to stone falling on other stone which had already fallen. The probable place of ignition was on a working face, where a fall involving a bed of siliceous sandstone, was being cleared. (Report on Marine Colliery explosion.)
Cwm Colliery, 1949: A fall occurred in a cavity at a roadhead; stone collapsed about eight feet on to an arch girder and produced an ignition. (Reports of H.M. Inspectors of Mines for 1949: South Western Division: Report by T. A. Rogers.)
Lewis Merthyr Colliery, 1957: Hard 'clift' fell from a roadhead cavity for a distance of 20 feet on to arch girders and produced an ignition. (Explosion at Lewis Merthyr Colliery, Glamorganshire: Report by T. A. Jones, O.B.E., Cmnd. 316.)
Mine in Virginia, 1958: Supports had been withdrawn from a section; an explosion associated with a fall occurred. Miners 50 to 75 feet from the fall saw sparks and a flash of fire just before the explosion. (U.S. Bureau of Mines Report of Investigations 5548 (Nagy and Kawenski).)