|
No. 113 differs materially from the three previous instances ; the boiler was cylindrical, constructed of excellent plate, and but little worn. It sustained a pressure of 42 pounds to the square inch, and was quite equal to it if all the appurtenances had been in like good order. On examination I experienced no difficulty in arriving at the cause of the calamity. It was provided with a 3-inch cast-iron pipe, which went through a bottom plate, and was protected from the action of the fire by brickwork underneath, consequently it was not accessible to examination. I found the casting defective to such an extent that the water had run out, its rapid flow being augmented by the action of superincumbent steam at a very high pressure. The side plates near the flues had then become red hot, and the fireman, seeing by the float gauge that the water was nearly exhausted, very imprudently turned on cold feed, which, flashing into steam of uncontrollable power, produced explosion, thereby completely reversing the position of the boiler, the whole mass and weight of which fell on the stoker, and must have instantly deprived him of life. He should have reported the matter to the engineer, who, from his more practical habits, would have damped the fire and cooled down his boiler before supplying it with water. When such blowing-out pipes as the one in question are used, they should not be made of cast iron, but of strong-riveted boiler plate, and so collocated as to be at all times easy of investigation. Source: 1857 Mines Inspectors Report, by Lionel Brough, H.M. Inspector of Mines, Page: 63
|
|||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 31 Dec 2022
|
Search |
|
|||