SPECIAL REPORT ON THE ELEMORE COLLIERY EXPLOSION.
Durham, 12th February 1887.
Sir,
In accordance with your instructions, I have the honour to make the following special report on the explosion which took place at Elemore Colliery about 10 minutes to three o'clock on the morning of the 2nd December 1886, when 28 lives were lost.
The inquest was held by Crofton Maynard, Esquire, Her Majesty's coroner for the Easington Division of this county, at the Hetton Colliery Inn, Hetton-le-Hole, on the 20th, 21st, and 22nd December 1886, and continued on the 18th and 19th January last. Mr. Cooper, Solicitor, of Newcastle-upon-Tyne, represented the owners of the colliery; Mr. Atherley Jones represented the relatives of the deceased; Mr. Haden Corser, Barrister-at-Law, attended and represented the Home Office. And I had the assistance of my colleague Mr. J. Willis, Chief Inspector for the Newcastle District, and Mr. W. N. Atkinson, and Mr. John Plummer, my two assistants in the Durham District.
The colliery is situated in the parish of Pittington, in the county of Durham, and is one of a group of large collieries belonging to the Hetton Coal Company, Limited, and was sunk during the years 1825 — 26, and has since been extensively worked in what are known as the Main Coal, Low Main, and Hutton Coal seams; the latter seam being nearly exhausted, the workings have lately been confined chiefly to the Main Coal, and Low Main Seams.
Two pits have been sunk to the bottom, or Hutton Seam, about 47 yards apart; the George pit being 13 feet diameter and 142 fathoms deep, while the Isabella pit is only 9 feet diameter and 129 fathoms deep to the same seam. This difference of level is caused by two fault slips near to the shafts, one of which runs in nearly a north and south direction, passing directly between the two shafts, and throwing the seams up towards the west about 8 fathoms, while the other, a little to the south of the George pit, is running nearly at right angles to the former and throws the seam up 3½ fathoms towards the north.
This has caused great confusion and complicated the work of making proper places for hanging on the coals in the shaft at the different levels. The arrangement is very difficult to understand, and even to describe, but the enclosed vertical section A. through the shafts, will enable you to follow the system of working.
The "George" pit is divided into two equal parts by a 3-inch wooden brattice, and forms two drawing shafts, the one on the east side being called the "Lady" pit, and the one on the west the "George" pit, both of which are used as downcast shafts. The "Isabella" pit is used exclusively as a furnace, or upcast shaft. The seams, it will be observed, are worked at three different levels, namely, the High, the Middle, and the Low. The High, or workings on the rise or west side of the 8 fathoms fault are called the "George" pit workings; the Middle, or workings on the north and east of the faults, are called the "Lyons" workings; and those on the east or low side of the faults, the "Lady pit" workings.
The connexion between the Low or Lady Hutton Seam, and the High or George Hutton Seam workings, is by a circuitous sloping stone drift, called "Allen's Drift." At the time of the explosion, the workings were confined to three different levels or hangings on, viz., the George (or High) Low Main; the Lady (or Low) Low Main; and the Lady (or Low) Hutton Seam.
The accompanying plan and sections A.A. on an enlarged scale, show the main intake way in the George Low Main Seam in detail, from near the shaft to the greaser, also views of the east and west sides of the arching and timbering up to that point; plan B., shows the workings in the George Low Main, in black; and the workings in the East Main Coal, connected by a stone drift on the same level called the "Dale Way," in brown. Plan C. shows the workings in the Lady Low Main, in brown; and the George Hutton Seam workings, in black, at the same level. Plan D. shows the workings in the Low, or Lady Hutton Seam. The two smaller plans, E. and F., show the workings in the Middle or Lyon's Low Main, and Hutton Seams, in which no coal workings have taken place for some years past. Very little effects of the explosion were exhibited in this section of the workings, except in the Lyon's Low Main, where all the crossings, stoppings, and ventilating doors were blown out.
The ventilation of the mine was produced by a furnace, 10 feet long and 7½ feet wide, with side doors for firing, which is placed in the Lyon's Low Main Seam at F. (marked on section A), near to the Isabella pit. Three men were employed at the furnace, working 8 hours each. They were supplied with small coal for this purpose, and the consumption was 9 tons in 24 hours. The total quantity of air passing over the furnace was measured on the day before the accident and found to be 100,078 cubic feet per minute. The return air from the three main coals and the pipe drift in the George Low Main districts, passed into the upcast shaft without coming in contact with the furnace, amounting to 53,114 cubic feet per minute, making the total ventilation of the mine 153,192 cubic feet of air per minute. The distribution of the air into the various parts of the mine will be better understood by a reference to the plans, and the following table of measurements of the air made as above stated.
| MEASUREMENT of AIR at ELEMORE COLLIERY, 1st December 1886. |
| Pits and Districts | Main intakes | Branch Intakes | Splits | Loss by Leakage | Remarks |
| | Cu. ft. per min | Cu. ft. per min | Cu. ft. per min | Cu. ft. per min | |
| West Main Coal | 21,912* | — | — | — | Not working |
| Low Hanging On | 2,976* | — | — | — | Not working |
| East Main Coal | 19,600* | — | — | — | — |
| Dale Way | — | — | 14,326 | — | — |
| Stone Drift | — | — | 3,184 | 2,090 | — |
| George Low Main | 37,840 | — | — | — | — |
| Derby Ways | — | 11,400 | — | — | — |
| Derby East Way | — | — | 6,116 | — | — |
| Derby South and West Ways | — | — | 4,824 | 460 | — |
| Moorsley Way | — | — | 7,602 | — | — |
| Hall Ways | — | — | 13,720 | — | — |
| New Polka Way | — | — | 5,068 | 50 | — |
| Stables | 1,032 | — | — | — | — |
| Pipe Drift | 8,626* | — | — | — | — |
| Lyons Low Main | 14,112 | — | — | — | — |
| North Way | — | — | 7,812 | — | Not working |
| Cross Cut Way | — | — | 5,478 | 822 | Not working |
| Lady Low Main | 8,550 6,363 | — | — | — | — |
| South Way | — | — | 13,772 | — | — |
| East Way | — | — | 1,032 | 109 | Not working |
| George Hutton Seam | 9,042 | — | — | — | Not working |
| Allans Hutton Seam | 3,000 | — | — | — | Estimated; not working |
| Lady Hutton Seam | 20,139 | — | — | — | — |
| North Way | — | — | 4,020 | — | — |
| 1st South Way | — | — | 6,120 | — | Not working |
| 2nd South Way | — | — | 9,440 | 559 |
| Totals | 153,192 | — | — | 4,090 | |
| |
| NOTE. — Marked thus *, amounting to 53,114 cubic feet, did not pass over furnace. |
The blue lines on the plans represent the intake air currents from the shaft into the face of each district, or split, and the red lines represent the returns, arrows marking the direction in which the currents travel. The distances from the shaft to the extreme end of districts are also marked on the plans in yards.