|
29th May 1943, Page: 288, Column: 2 Product And ProceedsThis was the subject of a paper by Mr. M. K. Burrows before the Manchester Geological and Mining Society, in which he said that in the colliery world the cost of production offers no guide in relating prices. He fears that scarcity and abundance have been the main factors in price structure; no worse basis could be found, for by its nature the system leads to instability and often to unfairness to consumers. He added to this the suggestion that we should look to the value to consumers as our yard stick. In the main the Author devoted his remarks to the markets — house, gas, industrial — and the problems they have to meet. Brief reference was made to the effect of underground methods, and attention was directed to surface manipulation. As stated, it is obvious that the value of a seam can be considerably reduced by breakage during manipulation on the surface, but most people would be very astonished and disturbed to find the extent of degradation that does occur even in carefully designed plants. Mr. Burrows proceeded to say : "Scrapers, if not very carefully designed, can do a lot of damage. In one case a scraper 60 feet long conveying 3-inch by 2-inch nuts caused 7.7 per cent. breakage to under 2-inch material. In another case a scraper 120 feet long tested on the same size of nuts broke 41 per cent. to below 2-inch, including 15 per cent. of material below ½-inch in size ; it is only fair to say that this latter scraper was neither designed nor used to convey nuts. "The simple operation of ploughing coal from a plate picking belt for loading into tubs caused between 5 and 10 per cent. breakage. "A series of tests were carried out to compare the amount of breakage that was caused by tipping coal through a number of different tippler and screening units. The method used was to hand-screen cobbles of a standard quality over a screen of the same size as that in the unit to be tested. These accurately sized cobbles were placed by hand into tubs so that everything that was tipped, unless degraded, should pass over the screen holes. The cobbles appearing on the picking belt were carefully taken off by hand, passed again by hand over a screen of a size of that in the shaker and weighed. The percentage of cobbles remaining of the original minimum size varied considerably as between the different screen units, the variation being between 91 per cent. and 76 per cent. It is satisfactory to note that the tipplers and screens producing the least breakage and most cobbles were of recent erection; the intermediate group were screens say 20 years old, and the worst offenders were the oldest — so that this is not a case of the juvenile offender. "It may be of interest to note that the screen and tippler tests were further analysed so as to tell how much breakage was caused by tipping and travelling down the shaker when the holes in the screen were covered by a blank plate and by deduction, therefore, how much was caused by the edges of the holes in the screen plate. It would appear that on the average three-fifths of the breakage was ascribed to the tippler and two-fifths to the perforations of the screen plate. Reduction in breakage on screens can be achieved by detailed attention. Projecting bolt heads, a too rapid constriction of the chute leading from screen to belt, and unnecessarily large falls on to solid surfaces are all prolific sources of breakage and are also usually reasonably easy defects to cure." On the subject of washeries Mr. Burrows submitted tables showing the degradations in size of the out-turn (including discard) of two washeries in comparison with the grading of the dry slacks. In one washery, if the original grading analysis of the dry slack had been reproduced in the products, the proceeds would have benefited by about 7d. per ton. In the other washery the loss in proceeds by degradation was estimated at 13d. per ton. These examples show that the degradation of coal incurred in passage through a cleaning plant can be very serious, but it is not assumed that the breakage occurred solely or even mainly in the wash box itself. For instance, at the second washery tests of hand sized material showed that the classifying screen caused 12 to 15 per cent. of large nuts to become undersize. This screen was of bad design and has been replaced.
|
|||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||