1st May 1943, Page: 258, Column: 1
Detection Of Heatings
In his paper before the North Staffordshire branch of the National Association
of Colliery Managers on "Spontaneous Combustion in Coal Mines,"
Dr. T. David Jones, Professor of Mining and Director of Research South
Wales Coal Owners' Research Laboratory, University College, Cardiff, said the
investigations carried out in the North Staffordshire and other coalfields were
confined to seams known to be liable to spontaneous combustion, and which seams
were in the main then worked by hand. During the last few years some of the
same seams have been and are being worked by modern machine mining methods of
coal cutting and conveying.
Reviewing the main differences obtaining between the methods of working, the
Author said the old method was hand-got, generally involving the gassing of the
gob, which in turn limited the quantity of ventilation into the panel being
worked ; in general a quantity of 5,000 cubic feet per minute per panel would
be regarded as liberal and frequently quantities of 2,000 cubic feet per minute
on the coal face would be satisfactory. The rate of face movement, generally
retreating, would be very slow.
The modern method is characterised by a regular and rapid face movement either
advancing or retreating, which generally means better roof control, a higher
and more rapid gas production which in turn means a higher quantity of
ventilation. A modern panel of the same main dimensions as the old method
panel, may require 12,000 and even up to 20,000 cubic feet per minute. In the
main, the roadways in the panel are of larger dimensions with machine mining,
thereby keeping the water-gauge across the panel about equal in both old and
modern methods ; this is a very fortunate factor With machine mining there is
much less coal being left in the gob inadvertently or otherwise, also there is
the more regular and complete withdrawal of timber and other supports. There is
the further more rapid consolidation of packs Which in turn reduces the air
leakages through the packs.
Typical analyses have been taken for the purpose of comparing on as wide a
basis as possible hand mining methods with machine mining in the same seams and
as far as possible under similar conditions. The main difference and one to
which attention was particularly called is the absence of CO in each case under
machine mining. In the hand-got working the normal CO/O2 figure in
three different seams, was about 0.5 per cent. whereas under machine mining
conditions it is nil. In machine mining, therefore, even the slightest trace of
CO must receive attention and be followed up quickly. It is of interest to note
that under the hand-got method where the normal CO/O2 figure was 0.5
per cent. gob stink occurred in a district when the CO/O2 figure had
reached between 2.5 and 3.0 per cent. In a case in the same seam with machine
mining gob stink occurred with a C0/O2 figure of just above 1 per
cent.
Points of interest mentioned by Dr. Jones were : It should not be
assumed that all machine mining districts will have normal CO/O2
figures of nil; there is a definite reduction in the
CO2/O2 figures between the two methods of working ; the
analysis of blackdamp method of interpretation is not as sensitive or reliable
as the CO/O2 method, which is strongly recommended.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Jones, T. David, Dr. | | Professor of Mining | |