6th March 1943, Page: 210, Column: 1
Prop Resistance
In his paper before the North Staffordshire Institute of Mining Engineers on "Research Problems on Falls of Ground," Dr. D. W. Phillips, M.I.M.E., referred to the question of prop resistance and roof and floor convergence. He said
:—
The useful life of a prop, as well as the resistance it offers, is dependent upon many things associated with its setting as well as upon the supplementary support offered by chocks and packs. Prop resistance is developed by the load transmitted to it
through the medium of the roof bed and the resistance to penetration offered by the floor bed. Both these are dependent upon the amount by which the roof and floor are allowed to approach each other, i.e., the amount of height reduction taking place,
while this in turn is largely determined by the control obtained over the higher beds by the packing and the effectiveness of any caving system employed. If the higher beds are kept under control they will not unduly load the roof bed and force it down
into the working area. By bearing in mind the supporting of the higher beds the roof control question is better appreciated. Another very important feature in the behaviour of supports is the relation between the amount of height reduction taking place
and the load-yield relation of the supports. A timber prop about 4 inches to 5 inches diameter and 5 feet long will shorten only about ¼-inch before breaking at a load of about 25 to 30 tons. It is reasonable to state that the few inches of height
reduction usually experienced on even well controlled faces are inevitable, and therefore it is evident that a prop set directly to the roof or to a steel bar will soon fail if it cannot be relieved by roof or floor penetration. In the accommodation of
height reduction the thickness of lid used is of some importance because of the measure of yield provided.
A feature worthy of local investigation is the relation between the height reduction taking place on coal faces and the behaviour of supports. Not only will information regarding height reduction give a measure of the roof control, but it will also
indicate whether the conditions are suitable for the strength capacities of the temporary supports.
A recently reported experiment in Yorkshire on the use of chocks and cantilever bars is worthy of note with respect to control of roofs at the face. In this method, which has also been successfully applied at another colliery, props are largely dispensed
with and the roof wholly supported by chocks with 4-inch by 4-inch H-section steel joists set between the chocks and the roof with about 3 feet projecting as cantilevers. This method supports a greater area of roof, is stronger, and results in less
wastage of supports. Further investigation into the application of this method is desirable and it might readily be of more universal application.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Phillips, D. W., Dr. | | Mining Engineer | |