31st October 1942, Page: 104, Column: 1
Lining For Steel Arches
Introducing the paper on "Tests on Linings for Steel Arches," before
the North Staffordshire Institute of Mining Engineers, Mr. W. H. Evans
(Safety in Mines Research Board) pointed out that the function of a lining for
steel arches is twofold : To prevent falls of ground between the arches, and to
stiffen and therefore increase the strength of the arches. A lining has also to
be simple to erect and easy to dismantle when the road is repaired, and it
should not in itself be a source of danger to men working or travelling on the
road.
It has been shown by laboratory tests on arches that a brick lining increases
the strength of arches of 4-inch by 2-inch by 2½-inch section and 8 feet
wide from 27 tons to 67 tons, i.e., nearly 2.5 times. Well lined arches 4-inch
by 2-inch by 2½-inch or 5-inch by 3-inch section weighing 11 or 12 lb. per
foot, were as strong as unlined arches of 5-inch by 4½-inch section
weighing 18 lb. per foot.
On the contrary, lagging laid over the backs of the arches does not stiffen
them satisfactorily, and struts or tics have to be used in addition. Holes
drilled in the web of the arch to fasten steel ties and struts weaken tho arch,
sometimes to a serious extent.
A lining which affords lateral support to the arches without requiring holes to
be drilled in the section adds considerably to their strength. Deep corrugated
sheets fitted between the flanges of the arches provide this support and are
themselves able to resist heavy ground pressure. Unfortunately such sheets are
made of thick gauge metal and may double or treble the weight of steel in the
road lining. In order to serve the same dual purpose without using steel, two
new linings have been developed in which concrete slabs or bricks are applied
in special ways.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Evans, W. H. | | S.M.R.B. | |