5th September 1942, Page: 54, Column: 1
Diamond Drill Bits
In an article in a recent issue of the Canadian Mining Journal, A. F. Raney
dealt with the question of modern diamond drilling. He remarked there
are many different kinds of diamond bits being used to-day. However, they can
be subdivided into two main types. These are the core type and the plug type,
with numerous variations in design and method of manufacture of each. Core bits
have been standardised in recent years and standard sizes give cores varying in
diameter from 7/8-inch to 2 1/8 inches. This system is convenient for holes
where the bit size has to be decreased with depth because of some obstruction.
Although the diamond drill, employing plug bits, was at first used quite
extensively in drilling holes for blasting purposes, the increase in the price
of carbons soon allowed its competitor, the ordinary hammer drill, to drive it
out of this field except in cases where the ore was exceptionally hard. In
recent years, however, cheaper, faster cutting bits have made it useful again
for mining certain types of ore bodies.
The rate at which a bit advances through the rock depends on the kind of rock,
the kind of bit, the pressure on the bit and its rate of rotation. Tests were
made in England in 1938 on the effect of varying the pressure and rotating
speed of a bit in rocks such as aplite, granite, limestone and sandstone. Some
bits were set with eight diamonds of ¼ carat each, and it was found that
the drilling speed increased with the rotating speed in all cases except that
of the sandstone at above 680 revolutions per minute. It was also found that
for these carbon bits, increasing the pressure increased the drilling speed.
Bort bits were also tested and it was found that a bit set with 100 diamonds
gave a 55 per cent. higher speed than a bit set with 40 diamonds. Insert bits
with high quality diamonds gave a speed in granite of 7 c.m. per minute, while
those set with cheaper stones gave a speed of 7.2 c.m. per minute (with, a
shorter life, however). The English type of sintered bit gave a speed of 6 c.m.
per minute, using a soft binding metal (in with the stones). In actual
operation, however, the ultimate speed of drilling depends only partly on the
above factors, as only about 69 per cent. of the total available time in a
shift is spent on actual drilling.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Raney, A. F. | | | |