11th July 1942, Page: 5, Column: 2
Mechanisation And Explosion Hazards
The following notes are extracted from the U.S. Bureau of Mines Information
Circular 7181 on "Status of Safety in Mining." The author is
Mr. D. Harrington, chief of the Bureau's Health and Safety Branch.
The mechanisation of coal mines unquestionably introduces additional explosion
and other hazards, although it affords numerous opportunities to decrease many
types of hazards that accompany more primitive mining practices and methods. In
addition to the mechanical hazards involved in mechanised mines, there is
almost invariably a considerable concentration of workers readily susceptible
to injury from any untoward occurrence ; moreover, the more rapid extraction of
coal as a result of mechanical loading liberates greater quantities of gas and
dust in a given period than does hand loading, and the gas is liberated in the
presence of an increased number of sources of ignition, chiefly in connection
with electrically operated equipment. Consequently, better ventilation must be
provided and greater vigilance maintained in the detection of gas and
elimination or neutralisation of dust. Many explosions result directly or
indirectly from carelessness or infractions of rules by employees and many from
unsafe methods, installations, or practices (or all three) for which the
management is responsible ; therefore, the prevention of explosions is the
responsibility not only of the management but also of the workers.
During the winter the cold air entering mines absorbs moisture and dries the
coal dust, making it more capable of being raised into the air, more readily
ignited, and more violently explosive upon ignition ; and during these months
particular precautions should be taken to prevent accumulations of explosive
gas or dust and the initiation of an explosion. This applies even more
emphatically to modern mechanised mines than to those still using the most
primitive hand-loading methods.
Pulverised rock dust, such as that from limestone, should be applied in
bituminous and lignitic coal mines to walls, roof, and floor of mine passages
to prevent propagation or extension of an explosion. When an ignition of gas or
of pure coal dust or a combination of both occurs, this pulverised rock dust
and the coal dust present on adjacent surfaces (floor, roof, and walls) are
raised into the air. The rock dust prevents the coal dust from igniting, which
localises the flame and prevents the explosion from spreading, or
"propagating" as it is termed. Experiments and experience have shown
that an explosion will not propagate or extend any considerable distance from
its origin in a mine that has been well-rock-dusted.
The partial rock-dusting of mines gives little or no real protection ; in fact,
it fosters a false sense of security, and in many instances the result is even
worse than if no rock-dusting were done. To provide adequate assurance against
widespread explosion disasters in coal mines all accessible open areas should
be thoroughly rock-dusted, including haulage entries, aircourses, rooms,
crosscuts, short or long faces, and pillar regions ; and the rock-dusting
should be repeated from time to time so as to hold the incombustible content of
the rib, roof, and floor dusts at all times to over 65 per cent.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Harrington, D. | | U.S. Bureau of Mines | |