11th July 1942, Page: 5, Column: 1
B.T.U. Values Of Coal
The discussion of "The Various B.T.U. Values of a Coal" is undertaken
by Messrs. J. F. Barkley and L. B. Burdick, of the U.S. Bureau of
Mines Fuel Economy Service, in Information Circular 7193. Appended are
extracts.
The inherent heating value or the amount of heat that will be produced when a
coal is completely burned is measured in British thermal units per pound of
coal. This standard heat unit is the quantity of heat required to raise the
temperature of 1 pound of water 1°F. at about 60°F. The amount of
inherent heat is determined by burning a small quantity of the coal in a heat
meter or calorimeter, which gives results in British thermal units. The value
so determined is the total heat developed by complete burning, with all the
products of combustion cooled down to the temperature of the calorimeter. The
calorimeter is kept at about room temperature. This total heat is sometimes
called the "high" or gross heat value, because it includes the latent
heat given up by the water vapour in the products of combustion when the vapour
condenses to water in the calorimeter. The heat as measured is reported as the
heat of combustion at constant volume, since the burning is carried out in a
tightly closed calorimeter chamber whose volume does not change.
The chemical elements in coal that produce essentially all the heat are carbon,
hydrogen, and sulphur. Therefore, the B.T.U. value of a coal as shown by the
calorimeter may be approximated by computation from Dulong's formula :
where C, H, O, and S represent the quantities (fractions, of a pound) of
carbon, hydrogen, oxygen, and sulphur in 1 pound of coal. One pound of each
element is considered to produce the quantity of heat expressed by the number
preceding it in the formula. It is assumed that all oxygen in the coal is
combined with hydrogen in the ratio of 8 : 1 to form water (H2O) ;
hence, only the remaining uncombined hydrogen is available for producing heat.
For anthracite, semianthracite, and bituminous coals the computed B.T.U. values
are usually within 1½ per cent, of the values determined by the
calorimeter. For sub-bituminous and lignitic coals the computed values often
deviate as much as 5 per cent. Causes for these differences include: (1) The
heating values given by the numbers in the formula may not be quite correct for
the conditions; (2) all the oxygen may not be combined with hydrogen, as part
may be combined with other substances, such as carbon ; (3) the percentage of
oxygen in coal is determined by subtracting the sum of all the other substances
found by analysis from 100 per cent., thus throwing all errors into the
percentage of oxygen ; and (4) the production of heat from coal is not as
simple as the formula indicates, since various heat reactions occur with other
substances in the coal, such as the burning of the iron in the ash. The
usefulness of the Dulong formula is quite limited. It is much simpler and
cheaper to make a calorimeter test than to analyse for the various chemical
elements in the coal. Formulae have been proposed at various times for the
calculation of the heating value from the "proximate" analysis of the
coal. The proximate analysis gives the moisture, volatile matter, fixed carbon,
and ash. Such formulae are apt to give unreliable results.
There are various ways of considering the B.T.U. value of coal. It is
ordinarily expressed as the B.T.U. per pound : (1) "As received" or
"as sampled" ; (2) "moisture free" or "dry" ; (3)
"moisture and ash-free" ; (4) "H" value ; (5) dry,
"mineral matter free" ; (6) moist, "mineral matter free."
For any one coal sample, all these values are related by values of the chemical
analysis of the coal. If the moisture, ash, and sulphur contents are known, any
one of these values may be calculated from any other.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Barkley, J. F. | | U.S. Bureau of Mines | |
| Burdick, L. B. | | U.S. Bureau of Mines | |