11th July 1942, Page: 4, Column: 1
Preservation Of Timber
In a paper before the Chemical, Metallurgical and Mining Society of South
Africa, on "The Preservation of Timber and Fabrics with reference to
Utilisation Underground," read by Mr. J. W. Bowen, M.Sc, of the
Timber Research Laboratory of the Transvaal Chamber of Mines, it was pointed
out that when timber is attacked by wood-destroying fungi several changes
occur. (1) There is a gradual loss in weight due to hydrolysis of the
carbohydrates, a series of intermediate products being produced until
ultimately carbon dioxide and water are formed ; (2) there is a corresponding
loss in strength ; and (3) there is a corresponding depletion of certain
chemical constituents of the timber. As far as the mines are concerned these
changes are particularly important, because they affect mining practice in a
number of ways.
Regarding the preservation of timber Mr. Bowen said :— In order to
preserve timber against fungal and insect attack, a preservative is applied
which is poisonous or repellent to these organisms. Preservatives can be
divided into three groups : (1) Oil preservatives, e.g., creosote, coal tar and
creosote derivatives ; (2) Water-soluble preservatives, e.g., zinc chloride,
copper sulphate, sodium fluoride and various arsenical preservatives ; (3)
Oil-soluble preservatives, e.g., copper naphthenate, copper oloate and copper
stearate and barium salts of the same acids.
The perfect preservative has yet to be discovered. It should be cheap, safe,
odourless, stainless and permanent.
All types of preservatives mentioned have both advantages and disadvantages
when used for the preservation of mining timber. Generally, all oil-soluble and
oil preservatives can be excluded on account of cost. It must be realised that
the effective life required from timber underground to a great extent governs
the cost and the efficacy of treatment that can be given. Untreated timber,
under conditions conducive to decay, i.e., temperatures of 80°F. and
relative humidities of 95 per cent., becomes so rotten that it loses its
effectiveness as support after a period of a year. By comparison, in stopes
where large quantities of timber are used, rarely is a life of more than four
years required from timber, consequently a cheap, relatively effective
preservative is all that is wanted to give this extra life. In drives, haulages
and permanent ways where considerably longer life is required, it is essential
that a more effective treatment, entailing greater absorption of preservative,
be given. The treatment of shaft sets is a somewhat different problem. Here an
extremely long life is required from this timber and it is profitable to use a
relatively costly preservative to ensure that the required life is obtained.
Unfortunately excellent preservatives, e.g., creosote, have some disadvantages
such as an unpleasant smell, being dirty to handle and inflammable. Whether or
not these disadvantages outweigh the increase in life obtained is a moot point.
In addition a number of water-soluble preservatives cannot be considered on
account of some individual disadvantages. The arsenicals are excellent
preservatives, but are unsafe for natives to handle and would present a grave
problem in a case of fire underground. Copper salts are also excluded as
treatment is carried out in iron cylinders and precipitation of the copper
results.
The present preservative used by the mining industry is a mixture of zinc
sulphate from the reduction works and triolith — one of the Wolman salts
— composed of sodium fluoride, potassium dichromate and dinitropbcnol.
Although no cases of dermatitis have been recorded, it is advisable to take
precautions and see the persons handling this salt wash and avoid unnecessary
contact as the dinitrophenol is extremely poisonous.
In the method of treating timber, investigations carried out have revealed that
a number of factors play an important part in the penetration and absorption of
preservative into timber. Briefly these factors are as follows :—
(1) Up to air pressures of 110 lb. per square inch absorption of preservative
increases correspondingly with the pressure.
(2) Most of the preservative is absorbed within the first five minutes.
Continued treatment, however, increases the quantity of preservative absorbed.
On being subjected to pressure for twenty minutes, timber absorbs 82 per cent.
of the preservative which it would absorb if subjected to the same pressure for
one hour.
(3) The temperature of the treatment solution in the case of relatively easily
impregnated woods has little effect on increased absorption.
(4) Dry timber absorbs more preservative than green timber. On the sap drying
out from green timber the pores become filled with air which is readily
replaceable with preservative.
(5) Drawing a vacuum prior to the application of pressure brings about a
considerable increase in absorption of preservative. Generally, drawing a
vacuum prior to the application of pressure, treating air-dried wood only and
applying maximum air pressure available for a reasonable time, are conducive to
better absorption and penetration of preservative.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Bowen, J. W. | | Transvaal Chamber of Mines | |