30th May 1942, Page: 323, Column: 2
Mining In India
"Bumps" and Experimental Longwall Workings
Mr. W. Kirby, B.Sc, M.I.Min.E., Chief Inspector of Mines in India, in
his annual report for 1940, refers to the occurrence in British India mines of
261 fatal accidents, attributing 197 to misadventure, 21 to fault of deceased,
10 to fault of fellow workmen, 20 to fault of subordinate officials, 11 to
fault of management, and 2 to faulty material. Out of a total of 1,483 persons
seriously injured his analysis shows that one was permanently and totally
disabled ; 67 were permanently partially disabled, and 1,415 were only
temporarily disabled. In addition to the foregoing, 12,880 persons received
minor injuries which necessitated enforced absence from work exceeding
forty-eight hours.
Falls of roof and sides caused 153 fatal and 353 serious accidents, the haulage
figures being 32 fatal and 307 serious accidents. These two items it will be
seen were responsible for a very high proportion of the accidents.
With further reference to "bumps" Mr. Kirby says that at Parbelia
mine, owned by the Bengal Coal Company, Limited, in the Raniganj coalfield, an
experimental longwall system of working in sections with solid sand stowing has
been introduced, and he is indebted to the Chief Mining Engineer of this mine
for the following details of this system of working : "The Dishergarh
seam, 15 to 16 feet thick and overlaid by strong sandstone beds, is worked from
two shafts, 1,466 and 1,478 feet deep. Sand stowing arrangements were completed
in 1938 and depillaring was commenced at a depth of 1,700 feet. Despite the
solid sand stowing of the goaves severe 'bumps' occurred continuously and the
management decided to experiment with the longwall system of working of the
seam in two sections. In the experimental method of working in the lower 7 feet
of the seam by a longwall retreating conveyor face, the coal is worked by hand
on a 300-foot long face and filled on to a belt conveyor which delivers it to
the loading road. The belt is moved every 12 feet of advance and sand is
solidly packed close to the belt as early as possible after the move up. The
minimum distance of the sand pack from the face is 8 feet, and the maximum
distance 20 feet, although a lesser distance is generally aimed at. The face
retreated a distance of 1,300 feet and no trouble with 'bumps' or falls was
experienced. The loading and return roads stand well."
Convergence measurements taken in the centre of the face showed the daily
average convergence was less than 0.5 inch and the average convergence for a
20-foot face advance over a period of 9 days was only 1½ inches ; this
indicates the high efficiency of the sand stowing. In the roadways the total
convergence over a period of 7 months was 10.82 inches whilst the face
retreated a distance of over 600 feet. Convergence measurements at selected
sites in advance of the face established that strata movements occurred as far
ahead of the face as 300 foot when a small increase in height between roof and
floor was measured. Convergence was first recorded when the face wiih 80 feet
from the measuring point and thereafter was continuous ; when the face had
retreated to the measuring site the extent of convergence was nearly one inch.
The extent and nature of convergence is of importance in roof control and
further work on the subject is being undertaken.
In another section of the mine at a similar depth galleries had been driven 15
feet wide by 7 feet high at 100 feet centres. Attempts to extract the pillars
so formed by taking 7 feet of bottom coal by longwall sand stowed conveyor
faces 300 feet long were abandoned as heavy "bumping" occurred each
time the face approached within 30 feet of a parallel gallery.
The evidence so far gathered from these experimental longwall workings is that
"bumps" can be eliminated by working this thick seam in sections by
sand stowed longwall faces and that under the given conditions such work is
preferable to the system of driving galleries to form pillars and then
extracting the pillars.
It would appear that the working of thick seams in sections with solid stowing
prevents sudden ruptures in the main roof which cause "bumps," and it
is anticipated that a system of work as detailed above will prove successful in
eliminating the serious "bumps" which are now being experienced in
extracting pillars in thick seams at great depths.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Kirby, W. | | Chief Inspector of Mines in India | |