21st March 1942, Page: 266, Column: 2
Fires And Bumps In Indian Mines
In his presidential address to the Mining, Geological and Metallurgical
Institute of India, Mr. W. Kirby, B.Sc.(Birm.), M.I.Min.E., stated that
fires due to spontaneous heating in the underground workings of mines
constituted one of the chief problems in the two main coalfields — Jharia
and Raniganj — of India. Fires have been caused due to "premature
collapses," i.e., uncontrolled as distinct from the ordinary controlled
collapses experienced in goafing operations. These premature collapses usually
result in the crushing of pillars, and this has been an important contributory
factor in a number of the fires. Apart from initiating or contributing to
spontaneous heating premature collapses introduce other dangers, e.g.,
accidents from falls of roof and sides ; the destruction of occupied surface
buildings and other property if the collapse has not been foreseen, and damage
to underground stoppings isolating fire areas, etc. Serious losses of coal have
also resulted, much of this loss being due to unsystematic development of
workings in the past and the lack of suitable precautionary measures to isolate
areas where spontaneous heating was likely to occur, and to prevent a fire
spreading from one mine to another.
It is generally known that sand-stowing of the underground workings would be
the ideal method for preventing fires underground, but hitherto only a few
mines in the coalfields have undertaken stowing where there have been suitable
facilities. As prescribed under the Coal Mines Safety (Stowing) Act, which came
into force in May, 1939, protective measures, including stowing, may be made
compulsory.
Turning to the question of "Bumps," Mr. Kirby said that as
development work has been completed an important problem in mines depillaring
at great depths is the occurrence of bumps and their inherent dangers. The
bumps arc likely to occur when the "cover" is about 1,000 feet or
more, and there is a thick strong stratum, e.g., sandstone, immediately above
or within a few feet of the coal seam. When large areas of coal have been
extracted, depending on the depth of the seam, bumps are likely to occur,
transmitting what might be called "shock waves" over considerable
distances. These bumps give little or no warning and, when violent, result in
the crushing of pillars and smashing of roof supports ; often a blast or wind
is produced which stirs up clouds of dust, and in gassy mines gas may be
liberated. Bumps vary in severity and occur in seams like the Dishergarh and
Sanctoria in the Raniganj coalfield, where pillars are being extracted at a
depth as much as 2,000 feet. In ordinary development work, provided the pillars
are sufficiently large to support the roof, bumps will not occur, and it was
not until a few years ago, when it was necessary to take out pillars at great
depths, that these increased difficulties in mining operations were
experienced. In view of the increasing importance of the question Mr.
Kirby said all avenues should be explored for reducing the frequency and
severity of bumps. It is considered that solid stowing of the goaf will do this
by retarding the rupture of the hard roof strata. At one mine, working the
Dishergarh scam, 15 feet thick, the seam is extracted in two sections. The
bottom seven feet of coal is taken out and the void sand-stowed, Mr.
Kirby explained, leaving the top eight feet to be taken out later and
stowed. It is anticipated that this system of working will not only result in a
limited settlement of the main roof but will allow the roof gradually to settle
down, thereby avoiding sudden ruptures with the accompanying serious bumps.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Kirby, W. | | President | |