7th March 1942, Page: 256, Column: 1
Coal Recovery From Dumps
In a paper on the practicability of recovering fine coal from slurry ponds and
dumps at collieries, read before the Yorkshire branch of the National
Association of Colliery Managers, Mr. John Crossland, of the Department
of Mining at the University of Leeds, said that any coal that could be obtained
from this source was of importance to the war effort and in the amelioration of
spontaneous combustion in dirt-heaps. In many instances it would also
facilitate the recovery of a considerable amount of pyrites, which was
invaluable at the present time. He believed there were thousands of tons of
slurry and coal available for recovery in many districts of this country.
One method of dealing with the material in dirt-heaps was to crush it and then
put it through a special coal recovering process. Where slurry had been
deposited on a heap, or was present in the form of a slurry pond, it was
suggested that it could probably be used by mixing it with other classes of
coal, or it might be recovered at a low ash-content after treatment.
It had been proposed that when the debris had been crushed the recovery of coal
could be made by froth flotation, slurry tables, and various other processes
using oil as a medium ; but Mr. Crossland called attention to a type of
table which had been in use in metal mining for years, and, more recently, had
been used in connection with coal cleaning plants for the recovery of fine coal
from slurry and for the clarification of washing water.
In the Mining Department of Leeds University a large number of tests had been
made in the recovery of fine coal and pyrites With one of these reciprocating
tables. Experience had shown that it was comparatively easy to separate from
dirt free coal over half an inch in size. Difficulties in the past had always
arisen in dealing with small coals, and before coal could be recovered in clean
condition it must be free from adhering dirt. The only way to make the coal
free was to break down the product to a size where the coal was no longer
attached to the dirt. It was desirable to leave the particles of coal as large
as possible, because the value for industrial purposes, except with boilers
using pulverised fuel, was reduced with each decrease in size.
Before any large scale cleaning process could be used, Mr. Crossland
stated it would be necessary to examine dumps carefully to see if pieces with
coal attached tended to accumulate at any particular point.
The author, who has examined samples of fine coal, averred that it had ash
contents of less than 10 per cent. Fine coal of this type had been readily
reclaimed, and was often used to a considerable extent as a boiler fuel. It was
suggested that, at some collieries, much of this material could be dug out
quite easily, and could be prepared for sale by passing it over a table to give
almost any desired ash content by arrangement of the discharge launders. Where
large pieces of attached coal and dirt were found at the bottom of the dump
these could be picked up, crushed and again cleaned to give acceptable
products.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Crossland, John | | | |