7th February 1942, Page: 230, Column: 2
Illuminating Colliery Picking Belts
In a paper on "Mercury Vapour Lighting (Horizontal Lamps on Colliery
Picking Belts)," read before the South Wales Institute of Engineers by
Mr. C. S. Chubb, M.Sc., of Cardiff University College, it was pointed
out that the problem of illuminating a picking belt resolves itself into the
even illumination of a narrow strip about 5 feet wide, by lamps at a height of
6 feet or more above the belt to avoid breakage, so that the light on the
effective parts of the belt is not less than 10 foot-candles and the average
not less than 15 foot-candles if the light has the colour of the mercury
discharge lamp. If other types of lamps are used a higher standard must be
achieved.
For the purpose of tests horizontal mercury discharge lamps were installed on
belts at a colliery; and the author concluded that from these surveys it may be
said that for the purpose of illuminating colliery picking belts, the
horizontal mercury discharge lamp offers a decided advantage over the vertical
type of lamp. A fitting properly designed for this purpose would probably
increase the advantage, and there is need for a fitting designed to give even
illumination of a narrow strip with a spacing of lamps equal to twice their
height.
Reference was made by Mr. Chubb in his paper to recently introduced
fluorescent daylight tubes. These are low pressure mercury discharge lamps
coated internally with a fluorescent substance so as to give a colour of light
approximating to daylight. When the use of coloured lights for coal picking was
first investigated by Prof. T. David Jones, various colours were tested,
including the daylight blue lamps then available. It was then clear that with
the same amount of illumination the colour of the mercury discharge lamp made
the shale and other deleterious matter much more visible than any other light
and the author has expressed the opinion arbitrarily that whilst an average
intensity of 15 foot-candles may be sufficient for mercury discharge colour, 20
foot-candles is necessary for daylight or the colour of light from tungsten
lamps.
It was possible to make a survey of some daylight tubes installed on a picking
belt and, whilst the installation was too new to form any definite conclusions,
the figures given in a test show that a high efficiency was obtained for a low
output of power. What was most interesting, Mr. Chubb said, was that the
belt alongside was illuminated by mercury discharge lamps giving much about the
same standard of illumination. It was thus possible to view the same samples of
material under the two colours, but with other conditions the same. This
brought out to a marked degree the superiority of the mercury discharge colour
over the daylight. Samples which were doubtful in daylight were clear in the
mercury discharge light. It is hoped to make such comparisons a subject of
measurement.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Chubb, C. S. | | Cardiff University College | |
| Jones, T. David, Prof. | | | |