|
27th December 1941, Page: 193, Column: 1 Concrete Props At Coal FaceProblem of Saving SteelThe subject of concrete props is one of practical importance at the present time as it is deemed desirable to supplement supplies of steel and timber. Despite the known limitations of concrete it is felt that every effort should be made to find out in what way and to what extent this material might be used as a temporary substitute. With this end in view the Lancashire and Cheshire Safety in Mines Research Committee as well as other expert bodies have taken in hand experimental work on the use of concrete in face props. A paper has been prepared and the hope is expressed that the information obtained will provide a basis for discussion and interchange of experiences and suggestions on the vital subject of steel and timber economy. In the paper on "Trials with Concrete Props at the Coal Face," which was presented by Mr. L. C. Timms, B.Sc. (Min)., at the meeting of the Manchester Geological and Mining Society on the 7th of December, the trials undertaken at a number of collieries are brought under discussion, the idea being that the notes may be of value to anyone contemplating further investigations, thus making it possible to obtain added experience in the practical application of concrete props before a real emergency occurs. There are ample supplies of cement in the country, and this it is said appears to be the only material available in sufficient quantities to supplement supplies of steel and timber. In some preliminary observations it is explained that a number of preliminary tests were carried out in an attempt to find the most suitable sites. These consisted of setting three or four sample props on a variety of faces, some of which were supported by timber and some by steel. These tests soon proved that: (a) Sufficient yield must be allowed to accommodate the convergence of the roof and floor during the time the props are set, either by floor penetration or some artificial cushioning device such as scuffing pots ; (b) The props required very careful treatment, by the persons handling, setting and withdrawing them ; (c) Intensive supervision was essential; (d) Concrete props were more likely to have a longer life on faces where the practice was such that convergence was kept low ; (e) Great difficulty was experienced where scuffing pots were used on uneven or steep floors to accommodate convergence. During setting the pots were tilted over on floors inclined at more than 1 in 5. As explained in the paper presented by Mr. Timms for consideration, arrangements were made at collieries for the trial of props. Two of the trials dealt with in the paper emphasise the vital necessity of ensuring that reinforced concrete props are used only as yielding supports. The question arose as to how saving in steel consumption was being effected by the use of reinforced concrete props in place of steel props, and a rough comparison was made with the average losses of steel props, on the same faces, as shown by the colliery records. The results of this comparison suggested that although a large saving of steel could obviously be effected in the initial equipment of a face with reinforced concrete props, there was a possibility of them consuming even more steel in maintenance. Mr. Timms said the fact should not be overlooked that in all the cases described, the concrete props contained at least twice as much steel as the 8 per cent. recommended by the M.D. Specification. It appeared, however, that if reinforced concrete props were to achieve their object, some improvement was necessary in the conditions of use or the durability of the props to increase their useful life, or alternatively, the steel must be recovered from damaged props and used over again. It was found that the best way to recover the steel fabrication from damaged props was to crush them one at a time under a steam hammer.
|
|||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||