|
29th November 1941, Page: 162, Column: 1 Survey Of Coal Utilisation FactorsUniversity of Illinois LecturesContinued from page 155. Coal Sampling. "Taking Chances in Coal Sampling" is dealt with by Mr. Henry F. Hebley*, who opens by saying that the sampling of coal is one of the most difficult problems to solve satisfactorily. Many factors work against success. Firstly, coal is a comparatively cheap commodity ; it is sold by the ton, not the pound, as in the case of metallic minerals. Therefore, any system of sampling adopted must be planned with a full realisation of the economic value of the material under scrutiny. Secondly, it should be remembered that coal is not a uniform material. The very manner in which it was laid down and formed has brought about an intimate mixture of materials of varying ash content from, say, 2 per cent. in the case of the purest of coals, to absolute rock. The pressures, buckling, cracking, etc., which the seam has experienced through the ages, together with the infiltration of the ground waters carrying deposits of lime, iron, and other impurities, leave the coal seam a very heterogeneous mass. Mining operations contaminate the product further through the inclusion of dirt from the roof and floor, and such adulteration will vary with the type of material lying adjacent to the seam in the working areas. Another important factor, which increases the difficulty of true representation, is the "size-weight ratio." Everyone familiar with coal has noticed the segregation brought about when coal comes to rest either in a pile or in a railroad car. This tendency of the larger particles to roll to the edges, leaving a core of fines in the centre, must receive adequate allowance in gathering the sample. Briefly, the "size-weight ratio" is a measure that has been introduced to take care of this factor. It has been studied and so arranged that the larger the size of the pieces in the coal being sampled, the greater should be the weight of each increment. In coal sampling, where the material varies in ash content, with particles from 6-inch cubes to the finest dust, and each of varying ash content, one can readily visualise the difficulty of obtaining true representation. This fact is becoming better appreciated, and amongst many of the individuals associated with the coal industry there is a growing tendency to adopt more modern methods of study in interpreting the analytical determinations of a coal characteristic to take into account this heterogeneity, or coal variability, by recognising it, measuring the same, and making allowance for its modifying influence. Tables are presented showing dry ash determinations and a sampling method for coal classed according to ash content. Regarding the practical application of the latter (commercial work), in short sentences each carrying a single thought, the author submits a few notes, some of which are reproduced :— Wherever possible, obtain the sample from moving coal. Always cut the stream completely with some receptacle, being sure that it is never filled to overflowing. As far as practicable, strive to space the increments uniformly throughout the coal sampled. Each sample should be reduced and analysed separately. The average of these determinations will give an estimate of the true characteristics of the coal sampled. Always remember that segregation has taken place when coal has come to rest. Great pains should be expended in attempting to obtain the right proportions of the various sizes that make up the coal pile ; and such a requirement is difficult to fulfil. Always dig down to the lower surfaces of the coal pile before taking the increment or cut. If moisture is a question, it is advisable to take a separate moisture sample weighing at least 100 lb. During the gathering of the increments, it is advisable to prevent, as far as possible, moisture loss to the air by drying. Try to adopt the thought that each laboratory determination is an indication of the coal's quality. While laboratory determinations are made on accurate scientific instruments by skilled technicians, it should be remembered that these laboratory determinations are no more accurate than the samples from which they are derived. Always remember that when you have but one determination of any coal characteristic, such as ash, there is no indication as to whether it is close to the average, or on the high or low side. On the other hand, if there are at least five determinations on a consignment, or bulk of coal, a good indication may be obtained of the coal's true worth if such coal contains approximately 6 per cent. ash or less. All gross samples should be crushed before dividing to the laboratory quantity. It may be said that more variability is brought about due to poor collection and poor reduction of the sample than by variation in the coal seam itself and the laboratory variations brought about by the manipulation of scientific instruments and by the analyst. [To be concluded.] * Coal Preparation Manager, Commercial Testing and Engineering Company, Chicago.
|
|||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||