15th November 1941, Page: 151, Column: 2
N.S. Bowling Alley Seam
In the report on "The Working of the Bowling Alley Seam in North
Staffordshire" prepared under the direction of the Safety in Mines
Research Committee of the North Staffordshire Institute of Mining Engineers,
and submitted by Mr. E. Steele for discussion at the last meeting of the
Institute, it is explained that the seam is extensively worked and it varies in
thickness from 2 feet 8 inches to 5 feet 3 inches. It is free from any dirt
bands. As a rule there are good partings at the roof and floor. In the southern
region of the area under review, the coal at the roof merges into a Cannel band
some 10 inches thick, and in these circumstances the coal does not easily part
from the roof. The general direction of the cleat is a north-west/south-east,
and is sufficiently pronounced to give the seam a friable character. Main slips
occur at intervals from 1 foot to 8 feet and follow the same general direction
as the cleat. The hade of these slips is sometimes to the rise, but more often
it is to the dip at an angle of about 70° to the horizontal.
The amount of firedamp produced by the working of the seam is not large or
troublesome — the average is about 500 cubic feet of firedamp per ton of
output. In no case does the amount of firedamp produced appear materially to
influence the line of face or the packing arrangements.
The working of the seam, though fully mechanised, does not produce large
quantities of coal dust. The roof is in some cases a strong shale some 3 feet
to 4 feet thick, while the floor of the seam in many cases is hard fireclay. In
others the fireclay is of a friable character, 2 feet to 4 feet thick, which
offers poor foundation for roof supports.
Packing in this seam presents no particular difficulty, since the roof produces
good packing material, and the height of the seam brings the top of the packs
within easy reach. On the whole, packing of at least 40 to 45 per cent. of the
waste gives satisfactory conditions. Steel props are used extensively ; on some
faces in conjunction with steel bars, on others with either wood bars or wood
lids. Where wood props are used, they are set under wood bars.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Steele, E. | | | |