|
1st November 1941, Page: 139, Column: 2 Survey Of Coal Utilisation FactorsUniversity of Illinois LecturesAt the fifth short course on Coal Utilisation held in the University of Illinois, presenting a programme of technical and practical information relating to coal and its utilisation, nineteen papers were presented, and they have been collected in Bulletin No. 7 Vol. 37 (Engineering Experiment Station Circular Series No. 39). The subjects dealt with by the authors were : The Fundamentals of Marketing ; Customer Turnover and Its Effect on Business ; What is Behind the Heating Complaint; Customer Demands ; The Smoke Problem ; Evaluation of Coal for Use in Domestic Stokers ; Coal Preparation ; Simplification of Coal Sizing ; Recent Improvements in Small Stokers ; Taking Chances in Coal Sampling; Designing Domestic Boilers for Stoker Firing ; Stoker-fired Warm-air Furnace in the Research Residence ; Coal Around the World ; Domestic Stokers ; Trouble Shooting on Domestic Stokers ; What Fuel Engineering is Doing for Coal; Fuel Engineering Service on Chicago and Eastern Illinois Railroad; Spreader Stokers and Their Place in the Picture : Coal Sizing. The price of the 180-page Bulletin is 50 cents net, the address in the event of inquiries being — The Engineering Experiment Station, University of Illinois, Urbana, Illinois, U.S.A. The programme of the course covers a wide field, of interest not only to those engaged in mining but others in the commercial sphere, who are manufacturing and distributing machinery for the preparation and utilisation of coal. Much of the information has an especial American appeal, but some extracts may be admissible and afford an opportunity to acquire a wider knowledge of problems to which the community has to devote attention wherever coal is mined and used. Coal Sizing. The concluding paper in the Circular relates to "Coal Sizing," the author being Mr. Joseph Harrington.* The following paragraphs are culled from his thought-provoking address :— We have always had coal sizing, but it is becoming progressively more refined and intelligent as its importance is better understood and appreciated. In the beginning, the lumps were loaded out and the fines thrown to one side or used as back-fill. As time passed, it was more convenient or economical to hoist all the coal, but the buckets were dumped on to an inclined grating and the fines fell through to be hauled away to the dump. An oil burner-designed for a light fluid oil would not be expected to handle a heavy, viscous oil. A gas burner adjusted for 300 B.t.u. gas would have to be carefully readjusted if 1,000 B.t.u. gas were to be used. Yet the mechanical stoker has heretofore been expected to handle any and every coal that happened to please the purchasing agent, whether it had 80 per cent, of nut and 20 per cent. of slack, or the reverse. Not only does coal of different sizes cause different amounts of draught loss, but the coking tendency is often affected by the proportion of fines. As if these were not enough, variation in the top and bottom sizes affects the loss in the ash-pit, the rapidity of ignition and the production of smoke. Another tremendously important fact is that coal undergoes a size change as it is transported, delivered, and handled. A product as bulky as coal and one which is handled in such vast quantities, must necessarily be moved around by mechanical means, winch removes any possibility of special care. As a result, the coal — except perhaps the finer screenings — that left the mine one size, arrives at its destination another size. The author knows of no other product approximating the importance of coal that undergoes such a definite change in both physical and chemical attributes between the point of manufacture and the point of consumption. In describing the size of a coal, a certain tolerance is necessary. This results in the use of an upper and lower limit, as is customary. The closer these limits are to each other, the less will be the range of sizes included in the group. In coal sizes the groupings must be such as to make the series continuous from largest to smallest; there must be enough to provide the fullest selection for all practical purposes ; and each group must be of such size as to prevent segregation within the group. Ability to blend any two or more sizes in any proportion desired would let the producer fill a prescription for a coal for any purpose. If it were found that a coal was degraded in shipment a certain amount, the percentage of the larger size would bo increased with almost mathematical precision so as to obtain the desired result at destination. A word as to segregation. This means a separation of dissimilar sizes when opportunity is given for gravity to act on those pieces large enough to flow or roll down an incline. It may be stated as a law that — (a) Separation will not occur when the sizes are substantially equal; (b) Separation will be minimised in a mixture of dissimilar sizes, if the smaller size is large enough to have individuality and be free of any packing quality. While all size names are now based on the screen openings, there is a tacit recognition of the importance of delivered sizes in the mind of the producer. If one producer adopts a 2-inch square mesh screen while his competitors cling to a 2-inch round hole, there is an instant reaction on the part of both buyer and competitor. The square hole will pass pieces distinctly larger than the round one, and thus the proportion of the coarse sizes will be stepped up. From the standpoint of the producer, as long as size dominates the price structure, this entails a distinct hardship, because the substitution of square for round holes, or oval holes for round ones, lets more coarse coal fall through, robs a higher-priced classification of some of its tonnage, and depresses the average realisation a distinct amount. It emphasises the fallacy of the whole system of size naming by screen sizes at the mine, and also the still more basic error of considering size alone as the measure of value. There is another variable in this matter of screen sizing. Mine screens are not merely plates with a lot of holes in them. Three important variables govern very decidedly the quality of the screened product. These are : (1) The pitch or slope of the screen, (2) The length of the screen, and (3) The rapidity of vibration of the screen. The effect of each of these upon the thoroughness of the screening process is too obvious to need explaining. The holes may be perfectly round, but unless all the other things are equal, the product may be anything desired. Taken in conjunction with the variable effect of hole shape, the whole matter of identifying coal sizes on the mine screen basis becomes little short of absurd. The undue weight currently given to mere size in evaluating coals is one of those things destined to be changed in the near future. (To be continued.) * Advisory Engineer, Northern Illinois Coal Corporation, Chicago.
|
|||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||