4th October 1941, Page: 97, Column: 1
Coal-In-Oil Suspensions
By Dr. F. W. Quass.
The possibility of using a suspension of finely-ground coal in oil as a
substitute for liquid fuel has been recognised for many years. These
suspensions are often misnamed "colloidal fuels." It is claimed that
a coal-in-oil suspension is superior to oil in that its calorific value per
unit volume is higher than that of the oil, and that, having a specific gravity
greater than unity, it can be stored under water. Much experimental work has
shown that suspensions can be burned satisfactorily in oil-fired furnaces in
which the burners will, however, require more frequent cleaning, and provision
for the prevention of slagging of the ash must be made.
In order to possess favourable burning characteristics, a coal-in-oil
suspension must have — (i) a low ash content, (ii) a high calorific
value, (iii) a low viscosity, and (iv) stability, i.e., the coal particles must
not settle out on storage.
From an economic point of view the coal content is, of course, very important,
since the larger the proportion of coal in a suspension the cheaper will be its
final cost. The premium coal content is the maximum percentage of coal that can
be incorporated in a suspension without causing the viscosity to be greater
than that of ordinary bunker fuels.
The principal details of the modified Trent Amalgamation Process are briefly as
follows : Coal is very finely ground with water. The pulp is then agitated with
oil. The oil forms a paste or an amalgam with the carbonaceous material. The
greater portion of the mineral matter remains suspended in the water and can be
separated. The impure paste is washed clean with water by churning.
In order to prepare the final suspension the cleaned paste is kneaded to free
it as much as possible from water and then diluted with an additional quantity
of oil.
It has been found possible to prepare coal-in-oil suspensions containing
approximately 30 per cent. of de-ashed coal, having 1.2 per cent, of ash.
The Grinding Factor.
The process of grinding is probably the most important factor affecting the
commercial application of the process. Apart from being a very costly item, it
influences the suspensions in many ways. For instance, an increase in the
period of grinding — (i) decreases the optimum coal content, (ii)
decreases the ash content of the suspended coal particles and thus of the
suspension, (iii) increases the viscosity, and (iv) increases the stability.
It is very likely that the explanation of these effects is to be found in the
size of the suspended coal particles. Thus an increase in the grinding time
will decrease the particle size and a better separation of mineral matter from
the smaller coal particles will be achieved. This will decrease the ash content
of both the particles and the suspension. The cleaner — and therefore
lighter — and smaller particles will remain more readily in suspension
and the stability of the suspension will be increased. The finer the coal the
greater will be the specific surface area of the coal particles. This will
increase the viscosity and thereby decrease the optimum coal content of a
suspension.
Factors which influence the viscosity of coal-in-oil suspensions are —
(i) The coal content — the greater the coal content, the higher will be
the viscosity,
(ii) The moisture content — the greater the moisture content, the higher
will be the viscosity,
(iii) The period of grinding — the longer the period of grinding for the
same coal and moisture content, the higher will be the viscosity,
(iv) The nature or composition of the oil used as suspending medium,
(v) The addition of small quantities of naphthalene decreases the viscosity.
The very important property of stability of a suspension is dependent on
—
(i) The size of the coal particles, hence the period of grinding. An average
particle size of 1½ microns is indicated. This requires six hours of wet
grinding in the porcelain ball-mills.
(ii) The nature of the oil used — tar distillate oil confers stability
more readily to a suspension than crude torbanite oil. This may be due to the
gradual peptisation of the coal particles by the tar distillate oil: the effect
of this is the development of a more pronounced gel structure which is readily
stable.
The optimum coal content of a suspension depends on —
(a) The time of grinding — an increase in the grinding period decreases
the coal content.
(b) The nature of the oil used for separating the mineral matter from the coal
and for diluting the coal-oil paste. Suspensions made from crude torbanite oil
can contain up to 40 per cent. of de-ashed coal, whereas suspensions made from
tar distillate oil can contain only up to 30 per cent. of coal.
* Extracts from paper on "Further Studies of Coal-in-Oil Suspensions"
presented at the June meeting of the Chemical, Metallurgical and Mining Society
of South Africa.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Quass, F. W., Dr. | | | |