6th September 1941, Page: 80, Column: 2
Drilling Equipment
In his talk on "Twenty Years' Progress in the Oil Industry" given by
Mr. L. A. Cranson before invited students at a meeting of the San
Francisco Section of the A.I.M.E., and reproduced in the official journal
(Mining and Metallurgy) of the Institute, he remarked that drilling and
development technique and equipment have shown great improvement in the past
twenty years.
In 1920, the greatest depth to which a borehole had been drilled was about
5,800 feet. By 1930, the maximum depth reached was approximately 10,000 feet,
and by 1940, 15,004 feet. Completion of producing wells at as much as 11,000 to
12,000 feet has become routine in many areas. Competent engineers are confident
that we will soon be drilling to depths in excess of 20,000 feet, or
approximately four miles.
At the beginning of the 20-year period, the derricks were built of wood. The
height of the more or less standard rotary drilling derrick was 114 feet, and
the base was 24 feet, though shorter wooden derricks were often used. The
maximum load which the standard wooden derrick would support approximated
400,000 lb.
In the early '20's, steel began to replace wood in derrick construction.
Although higher in first cost, steel derricks are longer-lived, stronger, less
of a fire hazard, and can be dismantled and moved from location to location or
skidded as a unit where conditions permit. The steel derrick is now standard
equipment, both in heavyweight drilling derricks and in lightweight, low cost,
pumping or production derricks.
The steel derrick has gradually grown in specifications until to-day some
derricks have a base of 32 feet, and are 176 feet high. These towers are
capable of handling loads of some 1,000,000 lb., and can handle the equipment
necessary to drill holes to depths of 15,000 feet or more. It is quite common
practice to remove drilling derricks from completed wells and erect a light
production derrick in its stead, or to leave the well without a derrick and use
portable equipment to perform any necessary work on the well, thus effecting a
great reduction in derrick cost.
Drilling equipment has been greatly improved, both as to size and efficiency of
operation, and may be powered with steam, electricity, Diesel, butane, or gas,
depending upon availability of a satisfactory supply of water, electricity,
gas, etc. Steam power is the favourite in most locations where cheap fuel,
usually gas, and a good supply of water are available.
In 1920, the power plant for a rotary outfit usually consisted of three or four
boilers of some 60 or 70 h.p. each, working at pressures of about 150 lb.,
usually manually controlled, uninsulated, and inefficiently operated, both as
to water and fuel consumption. The present boiler plant usually consists of
four or five boilers of from 80 to 150 h.p. They are largely automatically
controlled, but have a fireman in constant attendance who can manually control
them. They work at pressures of 200 to 500 lb. per square inch, are usually
insulated, and often supplemented by superheaters.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Cranson, L. A. | | | |