12th July 1941, Page: 9, Column: 1
Steel Arches And Spontaneous Combustion
With reference to their paper on "Prevention of Spontaneous Combustion by
the Use of Steel Arches as Road Supports," read before the Midland
Institute of Engineers, in subsequent discussion Messrs. D. MacGregor
and S. J. Temperley, the authors, said it had been their experience
throughout the pit that steel arches gave support much closer to the coal face
and also offered more resistance to side movement than was obtained by burying
the packs. The steel arch maintained the coal on the sides of the roadway in a
compact solid mass whilst it was lowering on to the accumulating resistance of
the packs, and this together with the fact that roof penetration had been
reduced in the area where rapid lowering was taking place, prevented
disintegration of the strata forming the sides of the roadway. The continuous
setting of the steel arch had only been applied to main airways and
cross-gates, because these were the roadways, especially cross-gates, where
trouble occurred more frequently than in other roadways. To meet the
requirements of ventilation and haulage, main airways and cross-gates were
ripped much earlier and maintained at a greater width than was necessary in
other roadways, but by using the steel arch the back ripping of the roof was
much reduced and was being done in more settled ground. The width of the
roadside pack in main gates and ribside gates was 4 yards in each case.
The authors explained that the system of steel-on-floor had been applied where
the advance of the face had been up to 200 yards per year, and their experience
led them to think that it would be equally successful on more rapidly moving
faces. It would not be possible to seal off all wastes periodically but the
first waste on the gob side of ribside gates was sealed off as often as
possible with the dirt available on each district. This waste was sealed off at
maximum intervals of 20 yards. In dealing with suspected heatings no more
digging out was done than was necessary to get the roadside wall far enough
back to provide the width required for the roadway, and water might be used to
saturate the ground before disturbing it. They did not consider the adoption of
stilts to be likely to save an extra ripping, as the foot of the arch near the
face was only about 12 inches off the floor. To enable the use of stilts longer
than 12 inches would necessitate extra ripping close to the face or setting the
arch nearer to the face.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| MacGregor, D. | | | |
| Temperley, S. J. | | | |