14th June 1941, Page: 396, Column: 1
Withdrawing Steel Arches
At a meeting of the South Wales Institute Dr. J. R. Dinsdale, in a paper
on "Roof Control and the Conservation of Timber and Steel Supports,"
gave a description of a machine in use at the Powell Duffryn Associated
Collieries (Ltd.) for the withdrawal of steel arches from old roads. It
consists of a small diameter drum round which the pulling rope is wound. The
pulling rope is attached to the arch being withdrawn, and the slack is taken up
by a handle placed on the drum shaft. The pulling power of the machine is
developed by a Sylvester, the chain of which passes round, and is attached to,
a large diameter pulley wheel on the drum shaft. The diameter of the small drum
on which the pulling rope is wound is 6 inches, and that of the pulley wheel to
which the Sylvester is attached is 24 inches, so that the pull of the Sylvester
is increased in the same ratio, i.e., 4 to 1.
In order to lift the arch, a pulley is clamped to the adjacent-arch. A rope is
then passed over this pulley and attached to the leg of the arch to be
withdrawn. For lifting rings that have been pushed into the ground a
considerable distance, a small headgear has been designed for use with this
machine. The headgear can be placed close to the ring and a more powerful
direct lift given to the leg of the arch. Where a still more powerful lift is
necessary, a lifting lever is used. For this purpose a clamp is placed round
the leg of the arch and the lifting bar, 4 feet long, is placed underneath it.
The bar is supported on a fulcrum and the pulling rope is attached to the end
of the bar. By means of this bar the pulling power of the rope is still further
increased by the leverage of the bar in the ratio of the lengths, i.e., about 4
to 1.
In addition to the much greater power developed by this machine, the men can
stand in a safe position well back along the road. This machine, when used in
conjunction with the specially designed clamps, headgear, and lifting bar,
etc., enables about four times as many rings to be withdrawn in a shift and
with less risk of accident.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Dinsdale, J. R., Dr. | | | |