3rd May 1941, Page: 340, Column: 1
Oxidation Of Anthracite
In the U.S. Bureau of Mines Report of Investigations 3546 Messrs. G. S.
Scott and G. W. Jones discuss the "Effect of Particle Size on
the Rate of Oxidation of Anthracite." In their introduction they say it is
self-evident that the temperature of a pile of broken coal will rise if the
rate of generation of heat exceeds the rate of heat dissipation and will fall
if the opposite is the case. Factors that affect the rate of generation of heat
are : (1) The quantity of heat liberated per unit of oxygen consumed. (2)
Partial pressure of the oxygen. (3) Temperature. (4) Degree of oxidation of the
coal. (5) Size of coal particles. (6) Humidity of the circulating air. (7)
Specific oxidation rate of the coal.
The Authors are concerned in the present Report with item (5), that is, size of
particles. In the combustion of anthracite at high temperatures the rate is
determined primarily by diffusion processes and in general is controlled by the
rate at which oxygen is admitted. However, when the oxidation takes place at
lower temperatures (400°C. or less, for example) the rate is determined
primarily by the velocity of the chemical reactions between the oxygen and the
coal. The phenomena observed are those of heterogeneous reactions in a
gas-solid system. The rate is proportional to the surface area or to the
reciprocal of the particle diameter. The surface area taking part in the
reaction may be somewhat greater or somewhat less than the superficial surface
area. The velocity of the primary reaction between the oxygen and the coal at
these lower temperatures is equivalent to one of the first order and is
therefore proportional to the momentary concentration of oxygen.
Another factor of importance is that the entire surface of the solid particle
does not react with uniformity. There is a "differential oxidation"
that increases the surface area ; this in turn increases the rate of oxidation
until a maximum is reached, after which the rate begins to decline. This
phenomenon has been utilised in the manufacture of gas-adsorbent carbons from
anthracite.
The experimental work undertaken consisted of two series of tests, leading the
Authors to aver that it is apparent that a definite relationship exists between
particle size and initial rate of oxidation and that it is independent of the
temperature (within the range 150°-400°C), the irregularities in the
curves being due, apparently not to actual bona fide and reproducible
variations but to rather large and not easily avoidable errors in
determination.
The surface area of any regular solid is proportional to the square of any
given linear dimension. Thus, the surface areas of a series of spheres are
proportional to the squares of their diameters (or to the squares of their
radii, etc.). For particles, the average specific gravity of which is constant,
the number of particles required for a given weight is inversely proportional
to their volumes or (for regular solids) inversely proportional to the cubes of
some given linear dimension. If the average shape of particle in each of the
different screen-size fractions is the same these particles may be treated as
regular solids. The total area of surface for a given weight of particles is
proportional, then, to the product of the square of some linear dimension and
the reciprocal of the cube of some linear dimension, or, simply, to the
reciprocal of a linear dimension. Thus, by considering this linear dimension to
be the mean diameter of particles, as determined by the screen dimensions, the
total surface area of 100 grams of dry coal should be inversely proportional to
the mean screen diameter. If the rate of oxidation were strictly a function of
the superficial surface area a logarithmic plot of rate versus reciprocal of
diameter of particles should yield a straight line with a 45° slope.
The effect of size of particles on the rate is an item of real importance. For
example, the 8- to 14-mesh size oxidises approximately twice as rapidly as the
4- to 8-mesh size. Accurate screening is thus a most important precaution. In
the tests one sample was crushed to pass about ¼ inch and was then
screened into the various sizes and placed in friction-top cans, so that,
barring breakage incident to handling, the sizes should have been readily
reproducible. On the other hand, the effect on the surface area of the sudden
expansions and contractions incident to placing the samples in the furnace and
removing them is not known but may be quite large. The rate varies directly as
the partial pressure of the oxygen. This has been corrected for, but the method
of making the correction is not as satisfactory as the Authors would like.
The change in rate with amount of oxidation seems to be complicated by the
appearance of another variable, namely, the change in area of the surface owing
to oxidation.
The Authors submit their conclusions as follows :—
Initial Rate of Oxidation. — 1. For sizes larger than about
20-mesh the initial rate of oxidation is directly proportional to the
superficial surface area within the temperature range studied
(150°—350°C.).
2. For sizes smaller than 20-mesh the initial rate of oxidation increases more
slowly than increase in the surface area and appears to reach a maximum beyond
which further sub-division of the particles has no effect within the
temperature range studied.
Change in Rate, of Oxidation with Amount of Oxygen Consumed. — 1.
For temperatures of 150°, 200°, and 250°C. the rate of oxidation
decreases regularly with time (or with increase in the amount of oxygen
consumed) for all sizes tested.
2. For temperatures of 300° and 350°C. : (a) For sizes under 20-mesh,
the rate of oxidation decreases regularly with increase in the amount of oxygen
consumed. (b) For sizes larger than 20-mesh, the rate of oxidation for a time
increases with increase in amount of oxygen consumed, reaches a maximum, and
then decreases with further increase in amount of oxygen consumed. This appears
to be due to development of a larger surface area by the oxidation process
itself.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Jones, G. W. | | U.S. Bureau of Mines | |
| Scott, G. S. | | U.S. Bureau of Mines | |