5th April 1941, Page: 315, Column: 1
Solid Stowing Advantages
In his paper before the South Staffordshire and Warwickshire branch of the
National Association of Colliery Managers, on "Solid Stowing by Mechanical
Means," Mr. W. A. Machin enumerated the following advantages
resulting therefrom :—
(1) There is better roof control at the face, with greater safety.
(2) With solid stowing, roof breaks are practically eliminated, and timber
costs are reduced to a minimum.
(3) The amount of subsidence with solid stowing can be calculated, and as the
roof does not break one knows exactly how far it will settle ; the distance a
road has to travel, how much coal has to pass down it, and therefore at the
face the road can be made large enough to last its useful life. Moreover,
practically all back ripping can be avoided, solid packing keeping the roof and
floor compact.
(4) Packs need not be buried in the roadways where solid packing is employed.
(5) Solid stowing enables thick seams of 20 to 30 feet to be completely
extracted, thus increasing the life of a mine.
(6) Surface damage is reduced to a minimum, subsidence being not more than
about 15 per cent., although less may be possible and should be aimed at.
(7) Only the dirt mixed with the coal need be raised to the surface, thus
reducing wear and tear on rolling stock, winding gear and ropes. The
coal-raising capacity is correspondingly increased.
(8) No leakage of air takes place through the goaf, thus ventilation is
maintained on the face.
(9) No gas can accumulate in the goaf or roof.
(10) Gob-fires are eliminated.
(11) Land is made available otherwise occupied by unsightly refuse dumps which
may become ignited by spontaneous combustion.
(12) The initial outlay on dirt-tipping machinery is saved.
(13) There is greater safety for the men employed.
At present there are available three systems of mechanical stowing, the oldest
being the hydraulic, which, while it has been used to some extent in India and
many years ago on the Continent, is generally regarded as impracticable in this
country. The second system is that of pneumatic stowing, and the third, one or
other forms of packing by the aid of centrifugal force. The last two have
already been proved in this country on a very limited scale, and in view of the
success of these pioneer machines it is remarkable that so little has been done
to develop the systems more extensively.
In the early days of coal mining very little dirt was sent out of the pits, and
it would seem that advances in technique have ignored the fact that it is only
coal that should be brought to the surface. In his paper in the Iron and Coal,
Trades Review Mr. Machin says there is no doubt that the extended use of
conveyors has contributed to the wasteful practice of sending dirt to the
surface, the excuse being the impossibility of stowing it on the face. While
there may be some truth in the statement, the fact remains that, generally
speaking, no effort has been made to provide suitable stowing places
underground, it being less trouble to bring the rubbish to the surface where
there was plenty of room. The cost of so handling the dirt was seldom put as it
should have been, against the tonnage of coal wound. Still less was any
consideration given to the possible advantages resulting from the proper
disposal of the dirt in the pit.
A dirt heap is not only unsightly but unhealthy, particularly, of course, where
the material is liable to spontaneous combustion. A census, covering a large
number of collieries where the coal is machine mined, shows that at least 1 ton
of dirt for every 3½ tons of coal is sent to the surface. Mining technique
has been revolutionised during the past 25 years ; consequently so have methods
of roof control and road support. The author believes that the next few years
will be responsible for very radical changes in the methods of handling dirt.
No dirt will be sent out of the pit, and existing spoil banks will find a
useful place below ground.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Machin, W. A. | | | |