|
8th March 1941, Page: 276, Column: 2 Coal CarbonisationIn the Carbonisation and Gasification section of his 1939 report Dr. F. S. Sinnatt, Director of Fuel Research, says it is a matter of importance to the carbonisation industry as a whole that methods of utilising coal should be available by which the amount of by-products obtained can be varied to meet the fluctuations in demand. The two intermittent vertical chambers erected by the Woodall-Duckham Company are 8 feet ¾ inch long, 16 feet 8 inches in height, 9½ inches wide at the top and 12¼ inches at the base. Equipment is available to permit of the accurate measurement of the products of carbonisation. The throughput of each chamber under normal gas-making conditions is 4.5 tons per day. The conclusions drawn from experiments with blends of different coals carbonised in these chambers, with flue temperatures of from 1,350°C. at the bottom to 920°C. at the top, are as follows :— (1) In every case the effect of adding weakly or non-caking coals to strongly-caking coals is the same, (a) The size of the coke tends to increase up to a point and then decreases. (b) The strength of the coke remains fairly constant up to the same point and then decreases sharply ; the friability of the coke, however, increases steadily, (c) The reactivity of the coke increases progressively, (d) The time of carbonisation and therefore the amount of heat required for carbonisation increases steadily as the amount of weakly-caking coal increases ; the difference between strongly-caking and non-caking coals when carbonised alone may be as much as two hours per charge, (e) Thermal yield of gas, and its calorific value, is decreased. In the absence of steaming at the end of the charge, the decreases in yield in the case of suitable blends are as much as 3 to 5 per cent. With the addition of non-caking coal to Durham coking coal the difference is greater. (2) The blending of strongly-caking coals can be applied with certain advantages if it is accepted that, under certain conditions, a loss of output may occur. The advantages are as follows :— (a) An increase of the range of coals available for gas manufacture to include coals not suitable at present except in the form of doubles or trebles. This may have considerable local importance, since the proportion of weakly-caking coal used in the blend may be as high as 50 per cent. (b) An increase of the combustibility of gas cokes. This is of special interest in view of the possibility of making cokes for the open domestic grate. The disadvantages are : (a) The output of gas of a stated calorific value is decreased. For example, Durham coal will yield 73 therms of gas per ton at a calorific value of 570 B.Th.U. per cubic foot while a blend with 60 parts of Warwickshire coal will give about 71 therms at 520 B.Th.U. per cubic foot. Although the difference in thermal yield is only 2 therms the decrease in calorific value is important. In a works supplying gas at say 500 B.Th.U. per cubic foot it would be possible to steam the Durham coal (8 per cent. steam) to give about 83 therms, while the blend could be steamed by the addition of only about 1.5 per cent. steam to give about 75 therms. This difference in output is important. (b) The time of carbonisation of a blend is greater and also the heat required for carbonisation. In the case of Durham coal the straight coal can be carbonised in 11.5 hours and a 40/60 blend in 12.5 hours. The differences in (a) and (b) mean that a given battery of retorts producing gas at 500 B.Th.U. per cubic foot would have a lower output when using blends by about 17 per cent.
|
|||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||