8th February 1941, Page: 244, Column: 1
Longwall System Of Stoping
In the discussion on the paper by Mr. A. V. Lange on "Stoping
Methods on Crown Mines" before the Institution of Mining and Metallurgy,
Mr. C. E. Jobling said he thought the longwall system of stoping would
be particularly suitable where banket reefs had reached the bottom of the basin
of the deposit. On the Rand the dip of the reef extended to a very great depth,
but in the Gold Coast the banket deposit lay in a succession of anticlines and
synclines, more or less at parallel with the strike of the outcrop.
Consequently at no very great depth the reef lay, no doubt, for a considerable
distance almost horizontally. Here the reef was not so consistent as on the
Rand, therefore there would probably be large blocks of low-grade ore left to
support the ground above ; but throughout the payable areas it was a question
whether small packs of any description would give sufficient support, whereas
the longwall system, as practised in collieries with what they called the goaf
carefully packed and following the face, might be the safest method of working.
Submitting a written contribution Mr. P. J. Crowle said his own view of
the subject was against a background of a lengthy experience of mining
extending to depths exceeding 8,000 feet below surface on the Kolar Gold Field,
India, where steeply-dipping reefs of varying widths occurred in hard,
crystalline and brittle schists, the orebodies being irregular in shape with
erratically distributed values. Faults, dykes, and intrusions of pegmatite
often had a local influence in the choice of a stoping layout and necessitated
modifications of supporting methods in the areas affected by them, while
rockbursts were an ever-present hazard. Except in a few restricted areas
longwall methods of reef extraction were impracticable and selective mining was
the general rule.
The longwall peak stoping described was a system permitting of the extraction
of the reef in one operation, the 100 per cent. removal not being affected by
problems of grade control. Theoretically this system was ideal as all remnants,
except the unavoidable ones formed between stope faces and striko faults and
dykes, were eliminated, and in this case the overlying beds appeared to be
sufficiently flexible to allow of the gradual growth and regular expansion of
the overhead dome. Such conditions might be expected to reduce to a minimum the
violent spasmodic fracturing which usually occurred in more brittle rocks. The
face, however, was not a true longwall face in the usually accepted sense, but
was a sharply serrated line with projections jutting out into the stoped area
for a distance dependent upon the distance between raises.
In his experience similar projections of the face into the stoped-out area had
almost invariably given trouble from bursting. Each projection formed an
advanced pier or supporting leg at the advancing edge of the overhead dome.
These legs offered resistance to the regular expansion of the dome, the weakest
points of the resistance being naturally in the region of each peak. As the
dome was extended in the direction of the dip the stress at the peaks might be
expected to increase.
The experimental longwall peak stoping described appeared to be in advance of
the general reef removal, and the excavation presumably had some advantage of
the natural support of the adjoining reef in situ. Under these conditions
interference with the main stresses in the hanging-wall might have been
temporarily avoided.
Interesting Speculation.
One of the most interesting speculations on the conditions which might be
encountered in future deep mining, in Mr. Crowle's view, was that
concerning the behaviour of rock under extreme pressures. Instances had been
observed where the appearance of the pressure-deformed rock suggested a close
approximation to disintegration and incipient rock flowage. It should be noted
in this connection that the static pressures due to superincumbent Weight alone
were enormously augmented by the live loads produced by continual movements and
surges of huge rock masses, and it seemed probable that the ultimate crushing
strength of the rock was sometimes exceeded. For a period of about eighteen
years seismograph instruments on the Kolar Gold Field were adjusted to record
these smaller movements and over this period upwards of 13,000 shocks per year
were recorded. Over the past ten years the records revealed that whereas the
major movements were diminishing, minor bursts were on the increase. This
continual yielding of the rock under extreme pressure was accompanied by a
continual release of stresses which otherwise would accumulate and produce the
heavier quakes. The constant shearing and fracturing movements appeared to have
the effect of a safety valve.
Mr. Harold D. Martin said that in coal mining the proper and most
economical method of working was from the boundaries homewards to the shafts,
allowing the ground to fall in behind the operation. That was economical from
the point of view of mining, but because capital was involved and people wanted
interest on their money those working the mine were more or less compelled to
work from the shafts outwards to the boundary. With metal mining nowadays and
the system of boreholes a great deal more was known about deposits than
formerly when, like the old Cornish miners, one started at the top and went
down further and further gradually until depths of thousands of feet were
reached. In view of the new results from boreholes and so forth, and the
knowledge of the reef, and with the new shafts which were sunk at very
considerable depths, it seemed as if rockbursts might be eliminated to a large
extent. The shafts having been sunk, the working of the mine might take place
upwards instead of downwards.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Crowle, P. J. | | | |
| Jobling, C. E. | | | |
| Lange, A. V. | | | |
| Martin, Harold D. | | | |