7th September 1940, Page: 75, Column: 2
Room Movement In Coal Mines
The third report of a series on convergence of roof and floor, prepared by
E. R. Maize, Edward Thomas and H. P. Greenwald for the
U.S. Bureau of Mines, is embodied in Report of Investigations 3506. It deals
with a mine in Washington County, Pennsylvania, and it is explained that
immediately above the coal and draw slate are the usual alternating thin beds
of coal and carbonaceous shale. In general, the section indicates roof strata
having little strength and ability to cantilever far out over the goaf. The
immediate roof coal and black shale break or shear vertically when pillars are
removed ; breaks in the gray-black shale usually occurred on an angle of about
30° from the vertical up to the sandstone. The falls were too tight to be
examined further. The immediate floor is coal, but where this bottom coal was
removed a hard fireclay stratum was observed. The thickness of the fireclay was
not ascertained. Where no coal is left to form the immediate floor, the
fireclay softens rapidly and tends to move into the openings.
From data presented in the report the following conclusions are drawn :—
1. Convergence is higher at crosscuts or other points where support is removed
in advance mining and is particularly high at points where the rib line
projects in uneven steps into the goaf area. Convergence readings are much
lower where the rib line is uniform. These findings bear out the practical
experience of mining men that uniform rib lines should be maintained to achieve
better mining conditions.
2. Significant convergence, 0.5 inch or more, is confined to a relatively
narrow belt not over 70 feet wide adjacent to the goaf area. This finding
appears to be a general rule that can be applied to mines operating in the
Pittsburgh bed, in which a large part of the coal is recovered on the retreat.
3. Surface subsidence is approximately 50 per cent. of the thickness of the
portion of the bed removed.
4. Lateral movement accompanying the vertical subsidence was, first, away from
the retreating rib line (downhill) and then back in the direction of the moving
line or against the slope of the hill ; the return movement did not restore the
points to their original location. The maximum distance moved by a point was
nearly 2 feet ; several points moved more than 1.5 feet.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Greenwald, H. P. | | U.S. Bureau of Mines | |
| Maize, E. R. | | U.S. Bureau of Mines | |
| Thomas, Edward | | U.S. Bureau of Mines | |