|
27th July 1940, Page: 32, Column: 1 Occasional Notes On ElectricitySound is conveyed through air by a wave motion, and this wave motion is caused by a movement of the particles of air backwards and forwards in a line with the direction in which the wave progresses. For the conveyance of every different sound a different motion of the air particles is needed, and if the characteristic motion of any sound can be impressed upon the air particles at any place, that sound can be reproduced. This, in short, is the underlying principle of the telephone. The earliest really successful instrument was produced by Edison (1878), and was based upon the variation of resistance principle. He took advantage of the fact that the increase of pressure between two conductors in contact produces a diminution in their electrical resistance. The substance chosen by him was carbon, its great variation of resistance under pressure having been independently discovered by him. Signalling between telephone stations is a necessity, and the apparatus by means of which this is effected is some form of electric bell operated by electricity generated either by a magneto machine or by a battery. The necessary switching is managed by the aid of an automatic switch which usually consists of a pivoted lever, so arranged that the mere hanging up of the receiver on one end of it changes the connection from the telephone circuit proper to the signalling circuit, and the unhooking or taking it off reverses this arrangement. What is an induction coil and what are its uses and purposes ? The induction coil consists of a bobbin having a central iron core surrounded by two distinct coils of wire. These coils bear varying proportions to each other as regards resistance, size of wire, number of turns, etc., and these proportions are determined by the specific purpose for which any particular instrument is designed. In telephony one of the coils, which we shall call the "primary," is made up of a short length of stout wire. From the fact that the makers of instruments usually wind this coil on the bobbin first, and surround it by the second coil, or "secondary," consisting of many turns of fine wire, the first coil is usually referred to as the "inner," and the second as the "outer." The primary circuit is joined up to the terminals of the battery, and the secondary includes the line and resistance instrument. In brief, the primary coil is made up of a few turns of stout wire having a low resistance, whilst the secondary coil consists of a great number of turns of fine wire having a high total resistance. In order to attain the greatest efficiency the resistance of the transmitter circuit must be kept as low as possible. If an induction coil is not used, and the receiver included direct in the battery and transmitter circuit, the resistance of the entire circuit must be kept low, for the efficiency decreases as the distance transmitted increases. Electricity and magnetism are closely connected; in fact, magnetism is primarily but a consequence of electricity and vice-versa, instead of being two distinct series of phenomena. The continuity of the effects produced in one circuit as distinct from the other is transmitted to that other by the action of magnetism operating through the iron core. The circuit of low resistance and few turns is of low E.M.F., while that of high resistance and many turns is of a correspondingly high E.M.F. Further, the current strength of the circuit of low E.M.F. is considerably greater than that of the circuit of high E.M.F. Between the current strength and number of turns of the low resistance, or primary circuit, and the E.M.F. appearing in the secondary circuit of many turns and relatively high resistance, a certain proportion exists. The high E.M.F. induced in the secondary coil enables it to overcome much resistance in the line and instruments at the other end. The variation of resistance in the microphone of the transmitter proper gives rise to corresponding variations of E.M.F. in the secondary circuit, and these operating on the magnet of the receiver in that circuit reproduce by means of the variations of the actuated diaphragm the original sound or sounds. The action of a transmitter is made up of three different actions as herewith : (1) Carbon decreases in resistance by pressure. (2) Carbon decreases in resistance with increased temperature. When the diaphragm of a transmitter compresses the granules or rods the resistance decreases. As a consequence more current passes and more heat is generated. This further assists in decreasing the resistance. (3) Decreased resistance on pressure due to increased surfaces in contact. Magneto switch-bells consist of four principal parts : (a) The magneto-generator, with its driving gear, by means of which the signalling currents are produced, (b) The polarised bell, which is operated by the currents produced by the magneto-generator, (c) The automatic cut-out, an arrangement for short-circuiting the generator coils when the generator is not being used, (d) The automatic switch. This differs but little from that used on battery switch-bells. What are polarised instruments ? They are instruments the moving parts of which are either magnetic in themselves or are maintained in a magnetic state by magnetic induction. Telegraphy pointed the way to their employment, for in this branch it is well known that these instruments respond best to rapid pulsations of current. — P.T.W.
|
|||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||