13th July 1940, Page: 16, Column: 2
Uses Of Reinforced Concrete
The following notes are extracted from the paper on "The Conservation of
Materials Used in Mines" read before the North Staffordshire Institute of
Mining Engineers by Mr. E. Steele (Investigator) :—
Reinforced concrete props are gradually coming into use underground as a good
and safe roof support. Seams with floors soft enough to permit of unsharpened
prop penetration are suitable for their application, and successful tests have
been made in seams with fairly hard floors using the Henshaw release device.
Tapered concrete props are being made to test their possibilities as to floor
penetration as a means of preventing their destruction. A concrete prop should
be at least 4 inches by 4 inches section, however short the prop ; any increase
in the cross-sectional area which can be accommodated will prove beneficial.
Where these props are likely to be struck with a hammer or where the Sylvester
chain is attached there should be either wood pads or ferodo protection wired
to the prop at that point. The crushing load of a well-made 4-inch by 4-inch
section 4 feet long reinforced concrete prop is in the order of 50 tons, equal
to about 5,000 lb. per square inch. Reinforced concrete props should always be
made in steel moulds. Only people possessing expert knowledge of reinforced
concrete manufacture are capable of producing first class reinforced concrete
props. Experiments are proceeding and it is a safe prediction to say that there
are many circumstances where good class concrete props will give satisfactory
and economical results.
Other underground uses to which reinforced concrete has been put include :
Track sleepers, blocks for the construction of air-crossings and such like
structures, and slabs for flooring for engine-houses and sub-stations.
Reinforced concrete track sleepers have been made and are simply doing the job;
different methods of attaching the rails have been adopted, the one using loose
bolts and clips being most satisfactory, whilst also being the most expensive.
At collieries where rail gauges are in the region of 30 inches care should be
taken to see that the section of concrete used gives the necessary strength.
Blocks for the construction of air-crossings and like structures are made in
sizes suitable for handling, being 2 feet by 1 foot by 9 inches. The blocks are
keyed together by grouting in a short length of round iron or steel into the
holes left to accommodate them. These iron or steel rod ties could be quite
efficiently replaced by using a brick as a tie. Flooring slabs have the
advantage that they can be made on the surface and easily transported inbye,
and they permit of that amount of floor movement which, oftener than not,
succeeds in cracking up the mass concrete, which is usually put down as
flooring in houses underground.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Steele, E. | | Investigator | |