Logo Museum
Museum
Friends of Durham Mining Museum
Events Calendar
e-Books and Books for sale
Photograph Gallery
Document Archive
Main Document Archive
Newspaper Articles
Articles by date
Articles by colliery
Personal name index
Local Record Extracts
D.M.A. Document Archive
Transactions of I.M.E.
Miners' Welfare
N.C.B. Archive
The Colliery Engineer
The Colliery Guardian
Mine & Quarry Engineering
Mining Journal
The Science and Art of Mining
Coal Magazine
Coal News
Coke and Gas
Master Name Index
What's new in the site
Mining
Mining History
Colliery Index
Colliery Maps
Company Overviews
Who's Who
Mineral Information
Managers Certificates
Educational Material
Bibliography
Statistics
Workers/Employee Lists
Notes for Family Historians
War Service information
Disasters
Disaster Reports
Names of those killed
Disasters in the 1700s
Disasters in the 1800s
Disasters in the 1900s
Memorials
Awards for Gallantry
On this day ...

Links to other sites of interest
Industrial Heritage Days Out
Former www.pitwork.net web site

Index to site

Contact and address details

Share Page with Social Media

Share on Facebook

Share with Reddit

Share on Delicious


 Newspaper Articles Index Newspaper Articles 

13th July 1940, Page: 8, Column: 1

Convergence Recording Device

Remarking, in reply to discussion before the South Staffordshire Institute of Mining Engineers of his paper on "Roof Control, Safety and Economy of Roof Supports," that a true conception of how much convergence took place at the working face could be gained only by actual measurements, Mr. J. W. Robinson said that at many collieries a simple wooden gauge or recording device was being used for this purpose. It resembled a timberman's measuring rod, having an inside piece sliding in an outer piece, but a small strip of spring steel was incorporated so that the two pieces remained in the desired position apart until pressure was applied. On the surface of the inner strip a boxwood rule, graduated in inches and tenths of an inch, was screwed. In use the gauge was set up between the roof and the floor at the face, and the rule was read in inches and tenths of an inch. Such measurements were taken regularly at fixed intervals of time between a fixed point in the roof and a point vertically under it, on the floor. As convergence occurred, the inner piece slid against the tension of the spring strip and a different reading was obtained ; the difference in the readings indicated the extent of the convergence. It had been found that a spike at the bottom of the gauge was sometimes preferable to a plain end, which might slide on a hard floor. A recorder board was placed in the deputies' office on the surface, and the graphs plotted in chalk and rubbed off when a fresh one was necessary. On this board each face was represented by a 12-inch square, which was divided into smaller squares having 1-inch sides, the top and bottom sides representing the day's and face advance in feet respectively, whilst the vertical sides indicated the amount of convergence in inches and tenths of an inch.


Names mentioned in this article

 

 Name  Age  Occupation  Notes 
Robinson, J. W.      


 

mail
Mail:
Webmaster
Back
Back
Home
Home
Open Government Licence   Contains public sector information licensed under the Open Government Licence v3.0.

Copyright © 1999-2024 by The Durham Mining Museum and its contributors
Registered Charity No: 1110608
Page last updated: 28 Nov 2022

Privacy Policy
 
Terms & Conditions
 
Search
Search
Print
Print