|
13th July 1940, Page: 5, Column: 1 Endless Rope HaulageIn the course of his written reply to the discussion before the Manchester Geological and Mining Society on his paper entitled "Endless Rope Haulage : Large Installations Working to the Dip," a summary of which was given in Nos. 22 and 23 Vol. 50 of this journal, Mr. E. H. Browne, B.A.Cantab., said it was necessary to state facts and not to stipulate factors which could not be achieved in practice. Plucking was one of the problems of endless rope haulage and further research was essential. He could not accept the suggestion that the full rope should pass round the return frame and then on to the surge wheel. In the first place, there should always be sufficient lead between the driving wheel and any pulley, perhaps in the neighbourhood of 100 feet. Secondly, the return pulley would take full maximum load, with consequent extra wear on the rope, whereas with the return frame fixed behind the surge wheel the rope tension thereon was considerably reduced. Tensioning at the haulage gear end was not recommended for larger haulage installations. There was no difficulty in tensioning at the bottom end, which was preferable in every way. Mr. Browne said he could not agree that 90 to 100 tons per square inch steel wire rope suffered appreciably more plastic wear. Wherever possible it was preferable to use this grade, but for large installations it was necessary to employ 100 to 110 tons per square inch, as diameter and weight were limiting factors. Nor could he agree that the return wheels should be of less diameter than the surge wheel. There was no real difficulty in the use of large diameter return wheels, but surge wheels were a major problem, as they affected the size of the haulage gear. The failure of intermediate shaft pedestal cap bolts could hardly be held against braking on the intermediate shaft, as the cause of such failure must manifestly have been due to poor design. The emergency run-back device was fitted to the slow-speed shaft so that when operated dynamic stresses were reduced to the minimum ; nor indeed would anyone suggest that it should be fitted to any but the slow shaft. The oil used in the "Thrustor" remained at a moderate temperature and did not require cooling. With reference to the standardisation of arches, Mr. Browne's company had reduced the number in use to about half a dozen and no difficulties had arisen. The length of the creepers in the 250 h.p. scheme was 36 feet on the slope, plus 7 feet on the bank-head, totalling 43 feet. No provision was made to ensure that the same axle of each set was engaged by the creeper, nor was this thought necessary. Duplication of the creeper motor and gears was obtained by holding standbys for each. The creeper was in direct line with the roadway, and the pull was therefore at the centre of the axles.
|
|||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||