15th June 1940, Page: 396, Column: 2
Roof Movement
At the May meeting of the South Wales Institute of Engineers
a paper on "Roof Movements and their Control on Some Conveyor
Faces" was presented by Dr. J. R. Dinsdale and Mr. J. M. Hughes.
This paper embodied research undertaken by the South Wales
and Monmouthshire Safety in Mines Research Committee in
conjunction with the Safety in Mines Research Board, work having
been done in fifteen districts at twelve collieries in the east and
west of the coalfield.
Most of the observations were made in seams where the floor
lift was so small compared with the roof subsidence that the
reading on the convergence recorder used could be taken for all
practical purposes as roof subsidence. The seams ranged from
2 to 7 feet in thickness and the depth from about 100 to 900 yards.
From the summary and conclusions given by the authors of
the paper the following notes are culled :—
Convergence measurements obtained in thirteen districts have
been plotted, and the graphs obtained illustrate the relationship
between convergence and thickness of seam. The average amount
of convergence rapidly increases with the thickness of the seam,
and results in more severe fracturing and loosening of the roof,
which in turn frequently causes the overloading and crushing of
temporary and permanent supports in the thicker seams.
Measurements show that pressure cycles of varying intensity
occurred on almost every face. Where the resistance of the
temporary or permanent supports was low, either because of weak
material or bad packing, the supports were unable to resist the
periodic loading due to these pressure cycles, and in these cases
the faces were subject to "crushes," occurring with 10 to 20-foot
face advance.
On some of the faces in addition to these "crushes" heavy
"weights" were experienced at intervals of too to 150-foot face
advance which gave rise to extensive and dangerous falls of roof.
To effect the maximum economy in timber and steel supports,
the resistance of both temporary and permanent supports should
be sufficiently high even in thin seams to keep convergence to a
minimum and at a uniform rate to eliminate cycles of pressure.
As the thickness of the scam increases the resistance of supports
should be increased, particularly in the deeper mines, and the
increase in resistance should bear a definite relationship to the
thickness of the seam.
In the thicker seams in the deep mines the permanent supports
are increased in strength by importing a plentiful supply of good
packing material, into the district.
In general, where the resistance of the supports was so low
that the convergence was above the average indicated, the
conditions on the face were poor, in some cases the faces being
subject to "crushes" or "weights." Where the convergence
was below the average, the conditions on the face were good.
Observations in front of machine-cut faces showed that coal-cutting
gave rise to roof movements that could be detected a
considerable distance in front of the face. These occurrences
show the special need for strong temporary and permanent
supports and promptness in erecting these where faces are machine-cut
if the resulting roof movements are to be effectively controlled.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Dinsdale, J. R., Dr. | | | |
| Hughes, J. M. | | | |