18th May 1940, Page: 357, Column: 1
Underground Fires
In his paper on "Underground Fires" in the Annual Magazine of the
Notts. Mining Students' Association Mr. F. Bishop says that underground fires
owe their origin to a variety of causes, and these may be classified as follows
: (1) spontaneous combustion, (2) naked lights, (3) friction, (4) electricity,
(5) explosions, (6) shot-firing, (7) miscellaneous causes.
Many underground fires are caused through spontaneous combustion, so that if
the coal is liable to self-heating every precaution should be taken to reduce
this heating as much as possible.
Open lights have also initiated many underground fires. These are caused
through the naked light coming in contact with timber, brattice cloth or other
inflammable material.
Excessive friction causing fires may occur at haulage pulleys, haulage return
wheels, bearings, brakes and at shaker conveyors.
Electrical fires may be caused through overheating of cables, defects in
electrical switchgear, or damage to cables or other electrical apparatus caused
through falls or runaway tubs.
Fires due to shot-firing may be started through firedamp being ignited when the
shot is fired, or by the ejection of smouldering particles from the shot.
Fires caused through sparks from coal-cutter picks, and fires caused through
the cutting chain running through piled up gummings, are examples under the
heading-miscellaneous fires.
Prevention is always better than cure and the following precautions will help
in reducing the risk of fire :—
(1) Frequent searches, to prevent persons taking into the mine prohibited
articles such as matches, cigarettes, or pipes.
(2) Use as far as possible of non-inflammable material underground.
(3) Provision of fireproof stores for oil and grease.
(4) Strict supervision of all electrical apparatus.
(5) The use of steel where possible in the construction of engine rooms, wheel
frames, etc.
(6) The establishment and maintenance of fireproof zones. These are usually
constructed of steel arches with metal laggings, and they should be made at
least 28 yards long at all vital points.
(7) By treating timber with some heat resisting compounds such as Mynex or
Ammonium Phosphate.
Underground fires may be classified under two headings, (1) superficial fires
and (2) deep-seated fires. Superficial fires are those which are in the initial
stages and with the burning material in small quantities, while deep-seated
fires are past the initial stages with flaming and glowing material in large
amounts.
The method adopted in dealing with a fire depends on many circumstances, but in
general superficial fires may be dealt with by the use of hand extinguishers or
by smothering with stone dust or sand. The method of dealing with a deep-seated
fire presents many problems and no definite rules can be laid down. The methods
adopted will depend on local conditions and the extent to which the fire has
developed. While preparations are being made to fight the fire, steps should be
taken to prevent any further development of the fire by the use of
extinguishers, sand or stone dust. An adequate supply of water should, if
possible, be conveyed to the site immediately.
In the case of electrical fires the first step to take is to make sure that the
current is switched off, and then apply sand, stone dust or use an extinguisher
of the foam type.
Oil fires may be successfully dealt with by using a foam extinguisher. Water
should not be used, except in a very fine spray.
There are two ways by which fires may be extinguished : (1) by-reducing the
temperature of the burning material below the ignition temperature, (2) by
preventing air reaching the seat of the fire. These results may be obtained in
several ways such as : (1) Use of portable extinguishers, (2) Application of
sand or stone dust, (3) Use of water in large quantities, (4) Sealing off the
area, (5) Flooding the area.
When a fire has been discovered, no time should be lost in attacking it. To
ensure this a good fire-fighting organisation should be maintained in the pit.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Bishop, F. | | | |