4th May 1940, Page: 341, Column: 2
Wet Drilling In U.S.
The subject of U.S. Bureau of Mines Information Circular 7072 is "Some
Data on Dust in Industrial Work." The Circular is from the pen of
Mr. D. Harrington, the chief of the health and safety branch of the Bureau. In his
reference to drilling methods in the States he says :—
Dry drilling is without doubt the dustiest occupation in mining, tunnelling,
and quarrying, and it continues to be used far too much in mine, quarry, and
tunnel work in the United States ; certainly, if dry drilling is allowed at
all, it should be done only with auger twist drills or with simultaneous use of
effective dust traps. Wet drilling, as practised in the United States with
water forced or drawn through the drill steel by compressed air, is now
"under fire" because it produces relatively large quantities of dust
even though the material floating in the air usually is wet. Much of this
criticism is imaginary but some of it is legitimate, and the trouble is due
largely to the fact that the holes are collared or started dry and, in some
instances at least, drilled dry for several inches. The dust caused by this dry
starting impregnates the usually stagnant air of the ordinary underground
tunnel or metal-mine working place and leaves it so for much if not most of the
working shift after the dry starting has been completed.
Sometimes the driller unduly limits the amount of water sent through the drill
steel, and while he nominally is drilling wet, the actual practice is closely
analogous to dry drilling because the compressed air that flows through the
drill steel forces excessive quantities of water-entrained dust bubbles or
particles out of the drill hole and into the air of the working place.
Sometimes, too, the drill is out of repair and allows far too much compressed
air to flow through the drill steel. When reasonable procedure is followed and
wet drills of present types are used the amount of dust from drilling can be
controlled ; in fact, this is actually being done by numerous alert,
conscientious mining and tunnelling companies. Some companies in the United
States and Canada are now experimenting with rock drills that do not allow
compressed air to go through the drill steel but require the water to be forced
through the steel by its own pressure ; these drills are said to cause less
dust than the usual types in which water is sent through the steel by
compressed air, but the practicability of the newer type of drill is debatable
and its use is still rather uncommon in the United States or Canada.
Without doubt, Mr. Harrington further observes, present-day wet drills can be
used so as to keep dustiness of air well within safe limits if employed with
care and judgment in collaring wet, using plenty of clean, dirt-free water,
keeping the drills in good repair with adequate regulation of the proportion of
water and compressed air flowing through the drill steel, preventing the
exhaust from the drill from impinging on nearby dusty surfaces of muck piles,
floors, walls, or timbers and throwing dust into the air, and planning, insofar
as feasible, to reduce drilling of upper holes to a minimum. Upper holes,
whether drilled dry or wet, are relatively heavy producers of dust in the air
of working places.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Harrington, D. | | U.S. Bureau of Mines | |