13th January 1940, Page: 224, Column: 2
Early Motors And Cables
Mr. J. E. Lambert, in his presidential address before the North
of England branch of the Association of Mining Electrical
Engineers, referred to electric motors of earlier days, and mentioned
that the direct-current motors were considerably improved on the
introduction of interpoles, which improved commutation. They
were perhaps more interesting than the straight 3-phase induction
motor, and in this connection he gave an account of an experience
which puzzled him as a youth. An 8 h.p. compound wound
direct current motor, for use in driving a centre-gate conveyor,
was received from the manufacturers, and Mr. Lambert was
instructed to test the run of this machine at bank, to verify that
it was O.K. before being sent into a Drift. He was pleased to be
given this work, as it was the first compound interpole machine
he had handled. The motor was connected up, connections
checked, but to his great surprise, on starting it up it started in a
clockwise direction on the first step of the controller, and continued
until the starter was halfway over, then suddenly stopped and
started in an anti-clockwise direction, and continued to run on
apparently all right. He tried several times, and then reported
the result of the test, but did not obtain much satisfaction, being
informed that it was quite possible to put this machine right
without a great deal of trouble. At the time he heartily disagreed
with this off-hand view but, nevertheless, he persevered and
eventually made the machine perform normally, and it was set
to work. Those machines laid the foundation, and the confidence
which led to the commencement of the conversion and replacement
of steam and air-driven plant by electric drive even in those
days the electric motor was applied to small winders and main
ventilating fans, the ease by which speed variation could be
carried out being a great asset.
Regarding cables in those early days Mr. Lambert remarked
that it could well be understood that they were subject to rough
usage, and especially so because the underground personnel had
not learned to understand that electric cables as well as all other
electrical gear had to be treated with respect. Mr. Lambert
instanced in illustration an actual happening. The night shift
chargeman called at the electric shop and suggested that an
electrician should be sent into a certain district to examine the
cables because, when he had been cutting up some props, he had
seen some sparks, and a considerable number of teeth were missing
from his saw. After examination it was found that he had not
only cut his prop-ends, but he had severed a pair of 19/16 S.W.G.
cables in the process.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Lambert, J. E. | | President | |