6th May 1939, Page: 339, Column: 1
Controlling Of Tubs
At the April meeting of the Midland Counties Institution of
Engineers the "Sixth Report of the Research Committee of the
Midland Counties Institution of Engineers: Haulage Accidents
in Normal Circumstances — Part II.," was presented by the
Investigator, Mr. W. H. N. Carter. In the investigation controlling
by hand, by locker, and by scotch were considered. The
appended brief notes are reproduced from the report :—
Control by hand. — The condition of the roadway at the operating
station contributes to many accidents included in this class. In
particular, the state of the floor affects the frequency of accidents
due to slipping and falling, which is influenced also by the type
and the state of repair of the boots worn by the operators.
Wherever possible the operator should stand at the side of the tub
that he is moving and should be careful to avoid putting his arm
at the back of the tub, as the approach of other tubs from behind
may result in a fracture of the forearm. At some shaft sidings
the gradient is such that the full tubs have to be started from rest
by pushing at the back of the tubs two safeguards, such as a
mechanical stop-block and a long scotch, are desirable to ensure
that there occurs no movement of the tubs behind those required
for the wind. Lack of systematic co-ordination amongst groups
of persons moving tubs between the same points sometimes leads
to accident.
Control by locker. — The risk of accident to persons occupied in
lockering or in removing lockers from tubs is affected by the form
of the locker and that of the tubs, and by the method of operation.
Several considerations enter into the design of the ideal locker.
It must be sufficiently strong. In this respect, lockers of steel
have an important advantage, for, although hardwood lockers,
2 inches or more in diameter, are strong enough, there is, where
wooden lockers are permitted, a risk that inadequate strips of
wood will be used as makeshifts. The locker must be easy to
insert, and easy to remove. There must be no risk of the locker
falling out if a momentary reversal of the tub's motion should
cause it to slacken. Because of the lesser friction with the wheel,
a steel locker is more likely to fall out than a wooden one, and to
overcome this the weight of the portion of the locker that is
through the wheel must be greater than that of the remainder.
There should be no risk of the operator's hand being forced upon
the tub frame. This can be achieved by including a cross-piece
and making the distance between it and the outer end of the
locker sufficiently great. The danger does not exist, however,
if in its "fast" position the locker is nearly level. It appears
that the ideal locker is one of steel, including some kind of a cross-piece,
and, when in position, having the greater part of its weight
within the wheel, and being nearly horizontal. Tubs having
bearings outside the wheels are more difficult to locker than are
the more usual type. A locker in a "fast" position in such a
tub has its inner end uppermost, and, unless it is weighted at
that end, is likely to fall out if slackening occurs. The less the
tub body overhangs the wheels and the less the distance it is
above them, the more necessary is the use of such a device as the
disc or the dagger.
Control of scotch. — Scotches may be used to stop tubs or to
control their speed. To stop tubs, a scotch made of soft wood and
sufficiently long to stretch across both rails, or one of hard wood
grooved to fit over a rail bead, is laid in position. The accidents
associated with scotching happen when tubs are being controlled
by a scotch which the operator holds in one hand and slackens
when necessary, usually by kicking. Injuries occur to the
operator's hands through being crushed beneath the tub-wheel
or between the scotch and the floor. To avoid such accidents
the scotch should be tilted downward, and it should be longer
than the customary 12 to 18 inches. If lack of space prevents
the use of a longer scotch, a handle may be fitted. The risks
of accident due to slipping or to the tub becoming derailed are
also less the more upright the position of the operator and the
farther he is from the tub.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Carter, W. H. N. | | Investigator | |