22nd April 1939, Page: 328, Column: 2
Sulphur In Coal
In their paper before the Combustion Appliance Makers'
Association on "The Problem of Sulphur in Coal,"
Dr. G. W. Humus and Professor A. C. Egerton said that comparison of the
percentages of "total" and "combustible" sulphur in British
coals would suggest that, as a rule, practically all the sulphur in
coal (other, perhaps, than the "sulphate" sulphur) would be
converted into oxides when the coal was burned and so escape
into the atmosphere. In point of fact, analytical figures for
"combustible" sulphate (so-called) may be misleading unless
their implications are fully understood. In the laboratory,
"combustible" sulphur is arrived at by deducting the sulphur
which is retained in the ash left when the coal is burned from
the "total" sulphur. It must be remembered, however, that
the determination of the ash in a coal is carried out under rigidly
controlled conditions (which are different from those obtaining
in practice), the coal being burned in a thin layer, at a temperature
of 775 deg. Cent. ±25 deg. cent. with free access of air,
i.e., in an oxidising atmosphere. When, on the other hand, coal
is burned on a grate, the bed of fuel is several inches thick and
reducing conditions prevail so that the ferric oxide in the mineral
matter is substantially completely reduced to ferrous oxide,
and sometimes, partially, to metallic iron. The grate-bars are
often attacked by sulphur, ferrous sulphide being formed, while
appreciable proportions of sulphides of lime, magnesia and ferrous
iron may result by reduction of sulphates in the mineral matter
and by partial fixation of some of the pyritic and "organic"
sulphur by bases. On balance therefore, it is probable that the
actual emission of oxides of sulphur when coal is burned on grates
is less than would be deduced from a knowledge of the "combustible"
sulphur in the coal.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Egerton, A. C., Prof. | | | |
| Humus, G. W., Dr. | | | |