|
25th February 1939, Page: 267, Column: 1 A Device For Arresting ExplosionsBy G. Allsop, F. J. Hartwell, and R. V. Wheeler. Excerpts from paper presented at the 49th annual general meeting of the Institution of Mining Engineers. From time to time the Safety in Mines Research Board has been asked to consider the possibility of supplementing the precautions against coal dust explosions that are now taken in British mines by the provision of some form of stone dust "barrier" which would automatically prevent the flame of an explosion from spreading the limited distance that even a properly stone-dusted road may allow it to do. The problem of checking an explosion rapidly might become of particular importance on a conveyor face where, should an explosion of firedamp occur, coal dust from the conveyor might add to the violence of the explosion and the flame might extend a considerable distance, along even a thoroughly stone-dusted road. In this form, the problem was recently again put before the Safety in Mines Research Board. Experiments were at once put in hand with a view to devising a reliable and rapidly-acting "barrier." An explosion, whether of coal dust or of gas, develops heat from its inception. If, therefore, the heat of the flame could be used to set free a sufficiently dense cloud of incombustible dust at some distance ahead of the explosion, it should be possible at least to curtail the distance over which coal dust, or a mixture of coal dust and stone dust, might extend the flame of a firedamp explosion. A heap of dust begins to fall under the action of gravity very slowly and, unless special provision is made for scattering the heap as it falls, much of it reaches the ground undisturbed and is for the time being ineffective in forming a cloud. A sure method of producing a cloud from a heap of dust is to fire it from the ground into the air. It was decided, therefore, to experiment with devices, to be brought into action by heat, for projecting dust into the air, e.g., by compressed nitrogen or carbon dioxide. Preliminary experiments on a laboratory scale, intended merely to test whether the scheme as a whole was feasible, and more particularly whether the heat of an explosion flame could operate a dust projector quickly enough, indicated that a cloud of a suitable dust could quench the flame of firedamp. This unexpected result naturally caused the direction of the experiments to be changed; for it would be eminently desirable to prevent the flame of a firedamp explosion from reaching coal dust, so that it could not be extended even for a short distance. It has been said that the quenching of the flame of firedamp by a cloud of incombustible dust was unexpected. It was known that, under certain circumstances, a vibratory firedamp explosion travelling along a tube of small diameter (e.g., 1½ in.) might be checked if there were a small heap of dust in its path. A brief account of experiments demonstrating this is given in an appendix to the Third Report of the Explosions in Mines Committee (1913). The action of the heap of dust in these circumstances appears to be mechanical; a vibratory explosion on a small scale is highly sensitive to the presence of a slight obstruction to its passage, such as the heap of dust provided. Recently (1933), researches in the laboratory of Dr. W. P. Jorrissen at Leyden University have shown that, if it is sufficiently dense, a shower of incombustible dust falling down a vertical tube containing a firedamp-air mixture can extinguish flame travelling slowly up the tube. In such an experiment the cloud of dust can be considered to have a quenching action. Large-scale Tests. Large-scale tests were carried out at the Research Station at Buxton in an explosion gallery 230 feet long and 4 feet in diameter, the object of the tests being to determine under what conditions the combination of a "thermometer," which (when exposed to the flame of an explosion) would actuate a dust-raiser, and a "mortar," from which dust would be projected as a cloud, would be unfailingly effective. The thermometer was strongly constructed, with a copper cylinder as the "bulb" (to assist the transference of heat to the air within it), and enclosed, save for the bulb, in an aluminium casing lagged with asbestos. The dust-mortar was made from a 3-foot length of steel tube, 1 foot in diameter. One end of the tube was closed by a steel plate on the inner surface of which a bayonet socket for the reception of the firing oap of a "Cardox" shell was fitted. The "Cardox" shell was supported axially in the mortar by a guide near its muzzle. The dimensions of this mortar had been so chosen that charges of fuller's earth up to 1 cwt. could be projected from it. Tests made to determine the "reaction-time" of this arrangement, that is to say, the time that elapsed between the establishment of the electric current through the "heater" within the "Cardox" shell, and the projection of dust into the air, showed that with the B 20 type shell, containing 11 oz. of carbon dioxide, 1 cwt. of dust was moved in about 0.2 second, whilst with the B 37 type, containing 20 oz. of carbon dioxide, the time was 0.12 second. Including the "reaction-time" (previously determined) of the thermometer, therefore, the time that would elapse between the advent of an explosion at the thermometer and the formation of a dust cloud could be about 0.15 second. If the flame of the explosion were travelling at a rate of 300 to 000 feet per second, the dust-mortar would have to be at a distance of 45 to 90 feet from the thermometer. The mortar was arranged beneath the gallery outside, with its mouth flush with the inner surface. Later on in the experiments the dust was projected from the mortar by firing a small charge of "Bobbinite," and later still by the firing of a charge of 1 oz. of a permitted (low-density) explosive. The Bobbinite was tamped with about 1 inch of clay, and a wooden disc, 11½ inches in diameter, was placed over the tamping before loading the mortar with dust. This disc prevented the explosive from merely blowing a hole through the layer of dust. For the principal series of experiments, one end of the gallery was closed permanently by a steel plate and the other temporarily by a wooden disc. The gallery was by-passed throughout its length by a pipe, 4 inches in diameter, connected to it at six equidistant points by 1-inch pipes and valves. The by-pass had a circulating fan installed in it and was connected to a 2,500 cubic feet gas-holder. This arrangement allowed the total volume of firedamp required to prepare a mixture of the desired composition in the gallery to be admitted in small quantities at the six points, and mixing was completed by running the circulating fan during one hour. When carrying out an experiment, the thermometer and the dust-mortar were fixed at the positions desired, the open end of the gallery was closed by the wooden disc and the firedamp-air mixture was prepared. The wooden disc was then quickly removed and the mixture ignited, at a point about 4-feet from the closed end, by firing a 5-gr. powder fuse. The distance travelled by the flame could be determined by the burning of strands of gun-cotton fixed at frequent intervals along the gallery. Summary and Conclusions. Arrangements are described whereby firedamp explosions can be extinguished. The arrangements involve the provision of (1) mortars from which a cloud of incombustible dust can be projected in the path of an explosion, and (2) thermal relays which, when subjected to the heat of an explosion, close an electric circuit which operates the mortars. In tests made in an explosion gallery 4 feet in diameter with 10 per cent. firedamp-air mixtures, the violent explosions obtained when ignition was at a closed end of the gallery and the flame travelled towards an open end have been stopped within 21 yards, and the milder explosions obtained when the gallery was open at both ends have been stopped within 4 yards. The incombustible dust found to be most effective was a common salt mixture (80 per cent. common salt, 18 per cent. french chalk, 2 per cent. magnesium carbonate), ground so that 80 to 85 per cent, passed through a 200-mesh I.M.M. standard sieve, the quantity required being about 2.5 lb. per square foot of the cross-section of the gallery. It is suggested that the arrangements should afford protection to a longwall face, and the gate-roads connected with it, from extensive explosions.
|
|||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||